Doraville, DeKalb County

BE BANH MI

5302 BUFORD HIGHWAY, SUITE A-5 ATLANTA, GA 30340

Food
Latest score
72
Mar 27, 2026
City
Doraville
County
DeKalb
Inspections
2

Score history

Inspection scores over time for this facility.

Inspection history

Georgia inspection history is score-based, with violations grouped under each recorded inspection.

Mar 27, 2026

Routine

Score: 728 violations

6-1A - proper cold holding temperatures

Regulation: 511-6-1.04(6)(f) - time/temperature control for safety; cold holding (p)

9 ptsCorrected: YesRepeat: No

Observed multiple time/temperature control for safety (TCS) foods cold holding at temperature above 41F - see foods marked with asterisk in temperature log. Upon checking, the ambient temperature of the cooler was 43F. CA: Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C) or below or 135°F (57°C) or above, except that roasts cooked to a temperature and for a time specified in subsection (5)(a)2 of this Rule and reheated using the same temperature and time conditions as cooking may be held at a temperature of 130°F (54°C) or above. COS: PIC discarded TCS foods that had been in cooler more than 4 hours (noted in temperature log). Other foods were moved to a working cooler.

4-2B - food-contact surfaces: cleaned & sanitized

Regulation: 511-6-1.05(7)(b) - food contact surfaces and utensils - cleaning frequency (p, c)

4 ptsCorrected: YesRepeat: No

Observed an employee move multiple baguette pans from the floor to the bread proofer and to the shelf where clean baguette pans are stored. CA: Equipment food-contact surfaces and utensils shall be cleaned at any time during the operation when contamination may have occurred. COS: PIC removed all unclean pans from proofer and shelf, set-up the 3-compartment sink and washed, rinsed and sanitizer the pans.

6-2 - proper date marking and disposition

Regulation: 511-6-1.04(6)(g) - ready-to-eat time/temperature control for safety food, date marking (pf)

4 ptsCorrected: YesRepeat: No

Observed multiple ready-to-eat, TCS foods (5 containers of cooked, sliced pork ; 2 containers of pate ; 3 bins of house-made cooked pork sausage) held under refrigeration for more than 24 hours with no date marks. CA: refrigerated, ready-to-eat, time/temperature control for safety food prepared and held in a food establishment for more than 24 hours shall be clearly marked to indicate the date or day by which the food shall be consumed on the premises, sold, or discarded, when held at a temperature of 41°F (5°C) or below for a maximum of 7 days. The day of preparation shall be counted as Day 1. COS: PIC date marked all foods.

8-2B - toxic substances properly identified, stored, used

Regulation: 511-6-1.07(6)(c) - storage, separation (p)

4 ptsCorrected: YesRepeat: No

Observed a container of floor cleaner stored on a shelf amongst containers of soy sauce and honey. CA: Poisonous or toxic materials shall be stored so they cannot contaminate food, equipment, utensils, linens, and single-service and single-use articles by: Separating the poisonous or toxic materials by spacing or partitioning; and Locating the poisonous or toxic materials in an area that is not above food, equipment, utensils, linens, and single-service or single-use articles. This requirement does not apply to equipment and utensil cleaners and sanitizers that are stored in warewashing areas for availability and convenience if the materials are stored to prevent contamination of food, equipment, utensils, linens, and single-service and single-use articles. COS: PIC relocated the floor cleaner.

8-2B - toxic substances properly identified, stored, used

Regulation: 511-6-1.07(6)(b) - working containers, common name (pf)

4 ptsCorrected: YesRepeat: No

Observed a spray container of blue liquid (later identified as soap) unlabeled. CA: Working containers used for storing poisonous or toxic materials such as cleaners and sanitizers taken from bulk supplies shall be clearly and individually identified with the common name of the material COS: PIC labeled the chemical container.

11A - proper cooling methods used: adequate equipment for temperature control

Regulation: 511-6-1.04(6)(e) - cooling methods (pf, c)

3 ptsCorrected: YesRepeat: No

Observed cooked chicken cooling using ineffective methods. Observed chicken on counter upon arrival at 86F. Employee stated it had just finished cooking and placed in cooler. Observed chicken at 79F after about an hour in the cooler. Container of chicken was tightly sealed and over 4 inches tall. CA: Cooling shall be accomplished in accordance with the time and temperature criteria specified under DPH Rule 511-6-1-.04(6)(d) by using one or more of the following methods depending on the type of food being cooled: (i) Placing the food in shallow pans; Pf (ii) Separating the food into smaller or thinner portions; Pf (iii) Using rapid cooling equipment; Pf (iv) Stirring the food in a container placed in an ice water bath; Pf (v) Using containers that facilitate heat transfer; Pf (vi) Adding ice as an ingredient; Pf or (vii) Other effective methods. Pf 2. When placed in cooling or cold holding equipment, food containers in which food is being cooled shall be: (i) Arranged in the equipment to provide maximum heat transfer through the container walls; and (ii) Loosely covered, or uncovered if protected from overhead contamination during the cooling period to facilitate heat transfer from the surface of the food. COS: PIC placed chicken in the freezer to cool rapidly.

15A - food and nonfood-contact surfaces cleanable, properly designed, constructed, and used

Regulation: 511-6-1.05(6)(a) - good repair & proper adjustment (c)

1 ptsCorrected: NoRepeat: Yes

Observed the interior of the prep top cooler leaking water.CA 1. Equipment shall be maintained in a state of repair and condition that meets the requirements specified under subsections (1) and (2)of this Rule. 2. Equipment components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications.

17C - physical facilities installed, maintained, and clean

Regulation: 511-6-1.07(5)(a),(b) - good repair, physical facilities maintained; cleaning, frequency & restrictions, cleaned often enough to keep them clean (c)

1 ptsCorrected: NoRepeat: Yes

Observed heavily soiled floors below the ovens, ranges, by the hand sink, and behind equipment. CA: The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products. Discussed to deep clean kitchen.

Apr 16, 2025

Routine

Score: 868 violations

1-2A - pic present, demonstrates knowledge, performs duties

Regulation: 511-6-1.03(2) - pic present (pf)

4 ptsCorrected: YesRepeat: No

Upon arrival, asked front food service employees for the person in charge. Employee stated they are not the person in charge. CA: There must be a person in charge on the premises of the food service establishment at all times. COS: Owner/Manager arrived towards the end of the inspection.

4-2B - food-contact surfaces: cleaned & sanitized

Regulation: 511-6-1.05(6)(n) - manual and mechanical warewashing equipment, chemical sanitization-temperature, ph, concentration, hardness (p,pf)

4 ptsCorrected: NoRepeat: Yes

Observed employee wash knife and white container without sanitizing solution. Observed employee wash blue cutting board with no sanitizing solution. CA:(n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows:

  1. A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P Concentration Range Minimum Temperature

MG/L PH 10 or less oF (oC) PH 8 or less oF (oC)

25-49 120 (49) 120 (49)

50-99 100 (38) 75 (24)

100 55 (13) 55 (13)

  1. An iodine solution shall have a minimum temperature of 68°F (20°C)P minimum concentration between 12.5 ppm and 25 ppm, P and pH of 5.0 or less or a pH no higher than the level for which the manufacturer specifies for the solution to be effective; P
  2. A quaternary ammonium compound solution shall have a minimum temperature of 75ºF (24ºC), P have a concentration as specified in DPH Rule 511-6-1-.07(6)(g) and as indicated by the manufacturer’s use directions included in the labeling, P and be used only in water with 500 ppm hardness or less or in water having a hardness no greater than specified by the EPA-registered label use instructions; P
  3. If another solution of a chemical specified under paragraphs 1 through 3 of this subsection is used, the permit holder shall demonstrate to the Health Authority that the solution achieves sanitization and the use of the solution shall be approved; P
  4. If a chemical sanitizer other than chlorine, iodine, or a quaternary ammonium compound is used, it shall be applied in accordance with the EPA-registered label use instructions ;P and
  5. If a chemical sanitizer is generated by a device located on-site at the food service establishment, it shall be used as specified in 1-5 of this subsection and shall be produced by a device that: (i) complies with law as specified in sections 2(q)(1) and 12 of the Federal Insecticide, Fungicide, and Rodenticide Act (FIFRA), P (ii) complies with 40 CFR 152.500 Requirement for Devices and 40 CFR 156.10 Labeling Requirements, P (iii) displays the EPA device manufacturing facility registration number on the device, Pf and (iv) is operated and maintained in accordance with manufacturer’s instructions. Pf.

4-2B - food-contact surfaces: cleaned & sanitized

Regulation: 511-6-1.05(7)(b) - food contact surfaces and utensils - cleaning frequency (p, c)

4 ptsCorrected: NoRepeat: Yes

Observed the interior of the ice machine with black/brown residue.CA: Except when dry cleaning methods are used as specified under subsection (7)(e) of this Rule, surfaces of utensils and equipment contacting food that is not time/temperature control for safety food shall be cleaned:

(i) At any time when contamination may have occurred;

(ii) At least every 24 hours for iced tea dispensers including nozzles and consumer self-service utensils such as tongs, scoops, or ladles;

(iii) Before restocking consumer self-service equipment and utensils such as condiment dispensers and display containers; and

(iv) In equipment such as ice bins and beverage dispensing nozzles and enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment:

(I) At a frequency specified by the manufacturer; or

(II) Absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold.

16B - plumbing installed; proper backflow devices

Regulation: 511-6-1.06(2)(r) - system maintained in good repair (p, c)

2 ptsCorrected: NoRepeat: No

Observed leaking hand sink in the corner of the main kitchen. CA: Advised to repair. CA: A plumbing system shall be repaired according to law; P and maintained in good repair.

15A - food and nonfood-contact surfaces cleanable, properly designed, constructed, and used

Regulation: 511-6-1.05(6)(a) - good repair & proper adjustment (c)

1 ptsCorrected: NoRepeat: No

Observed the interior of the prep top cooler leaking water.CA 1. Equipment shall be maintained in a state of repair and condition that meets the requirements specified under subsections (1) and (2)of this Rule. 2. Equipment components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications.

15B - warewashing facilities: installed, maintained, used; test strips

Regulation: 511-6-1.05(3)(h),(i),(j) - temperature measuring device, manual warewashing; sanitizing solutions, testing device (pf)

1 ptsCorrected: NoRepeat: No

Observed expired quat sanitizer test strips. CA:Advised PIC to obtain quat sanitizer strips by the end of day 4/16/25. CA: A test kit or other device that accurately measures the concentration in mg/L of sanitizing solutions shall be provided. Pf

17C - physical facilities installed, maintained, and clean

Regulation: 511-6-1.07(5)(n) - maintaining premises, free of unnecessary items/litter (c)

1 ptsCorrected: NoRepeat: No

Observed a chest freezer and hand sink behind the plaza.CA: The premises shall be free of items that are unnecessary to the operation or maintenance of the establishment, such as litter or equipment that is nonfunctional or no longer used and litter.

17C - physical facilities installed, maintained, and clean

Regulation: 511-6-1.07(5)(a),(b) - good repair, physical facilities maintained; cleaning, frequency & restrictions, cleaned often enough to keep them clean (c)

1 ptsCorrected: NoRepeat: No

Observed heavily soiled floors below the ovens, ranges, by the hand sink, and behind equipment.CA: The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products. Discussed to deep clean kitchen.