7 Leguas Mexican Restaurant

Observed pink/green substance on the baffle of ice machine. Advised PIC to remove ice from machine for proper cleaning. Rule: 511-6-1.05(7)(b) - Food Contact Surfaces and Utensils - Cleaning Frequency (P, C) (b) Equipment Food-Contact Surfaces and Utensils. (iv) In equipment such as ice bins and beverage dispensing nozzles and enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment:

(I) At a frequency specified by the manufacturer; or

(II) Absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold.

Observed uncovered meats in containers in the reach in cooler. PIC placed lids on all of the specified items. Rule: 511-6-1.04(4)(c)1(iv) - Packaged & Unpackaged Food, food stored covered(C) (iv) Except as specified under paragraph 2. of this subsection and when cooling as specified in DPH Rule 511-6-1-.04(6)(e)2.(ii), storing the food in packages, covered containers, or wrappings, except for loosely covered or uncovered containers in which food is being cooled if protected from overhead contamination;

Observed dining plate submerged/covered under the lettuce on the prep top table. PIC discarded the lettuce and tomatoes then removed the plate for wash rinse and sanitize. Rule: 511-6-1.04(4)(k) - In-Use Utensils, Between-Use Storage (C) (k)Storage of In-Use Utensils. During pauses in food preparation or dispensing, food preparation and dispensing utensils shall be stored:

1.Except as specified under paragraph 2 of this subsection, in the food with their handles above the top of the food and the container;

2.In food that is not time/temperature control for safety food with their handles above the top of the food within containers or equipment that can be closed, such as bins of sugar, flour, or cinnamon;

3.On a clean portion of the food preparation table or cooking equipment only if the in-use utensil and the food-contact surface of the food preparation table or cooking equipment are cleaned and sanitized at a frequency specified under DPH Rule 511-6-1-.05(7)(b) and (8)(a);

4.In running water of sufficient velocity to flush particulates to the drain, if used with moist food such as ice cream or mashed potatoes;

5. In a clean, protected location if the utensils, such as ice scoops, are used only with a food that is not time/temperature control for safety food; or

6. In a container of water if the water is maintained at a temperature of at least 135°F (57°C) and the container is cleaned at a frequency specified under DPH Rule 511-6-1-.05(7)(b)3(vi).

511-6-1.05(7)(b) - Food Contact Surfaces and Utensils - Cleaning Frequency (P, C) (b) Equipment Food-Contact Surfaces and Utensils. (iv) In equipment such as ice bins and beverage dispensing nozzles and enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment:

(I) At a frequency specified by the manufacturer; or

(II) Absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. Note: Observed mold-like accumulation on baffle of ice machine. PIC instructed to empty, wash and sanitize ice machine.

511-6-1.04(6)(e) - Cooling Methods (Pf, C) (e) Cooling Methods.

1. Cooling shall be accomplished in accordance with the time and temperature criteria specified under DPH Rule 511-6-1-.04(6)(d) by using one or more of the following methods depending on the type of food being cooled:

(i) Placing the food in shallow pans; Pf

(ii) Separating the food into smaller or thinner portions; Pf Note: Observed large pans of shredded chicken in small ice baths. PIC separated pans into smaller ones to ensure proper cooling could be achieved.

511-6-1.04(4)(m) - Wiping Cloths, Use Limitation (C) (m) Wiping Cloths, Use Limitation.

1. Cloths in-use for wiping food spills from tableware and carry-out containers that occur as food is being served shall be:

(i) Maintained dry; and

(ii) Used for no other purpose.

2. Cloths in-use for wiping counters and other equipment surfaces shall be:

(i) Held between uses in a chemical sanitizer solution at a concentration specified under DPH Rule 511-6-1-.05(6)(n); and Note: observed multiple rags out of sanitizer solution on top of food prep areas. PIC removed rags from areas and placed clean new rags in sanitizing solution.

511-6-1.07(5)(k) - Controlling Pests (Pf, C) (k) Controlling Pests. The presence of insects, rodents, and other pests shall be controlled to minimize their presence on the premises by:

1. Routinely inspecting incoming shipments of food and supplies;

2. Routinely inspecting the premises for evidence of pests; Note: Observed living and dead flies in multiple locations throughout facility.

511-6-1.05(1)(a) - Materials, General Requirements (P, C) (1) Materials.

(a) General Requirements. Utensils and food-contact surfaces of equipment shall be made of materials that do not allow the migration of deleterious substances or impart colors, odors, or tastes to food and under normal use conditions, and shall be: P safe P, durable, corrosion-resistant, and nonabsorbent. In addition, materials shall be sufficient in weight and thickness to withstand repeated warewashing and shall be finished to have a smooth, easily cleanable surface. Materials shall be resistant to pitting, chipping, crazing, scratching, scoring, distortion and decomposition. Note: Observed knives on knife magnet with tip missing and or beginning to chip off. PIC voluntarily threw away knives.

Improper cooling methods being used for three pans of fried beans, were sitting on the prep counter. Finished cooking and put into the pans at 2pm. First temperatures taken at 2:15pm - see temp observations. PIC put all three pans in an ice water bath inside the walk-in-cooler to COS. Second temperatures taken at 3:10pm - see temperature observations.

Cooling shall be accomplished in accordance with the time and temperature criteria specified under DPH Rule 511-6-1-.04(6)(d) by using one or more of the following methods depending on the type of food being cooled: (i) Placing the food in shallow pans; (ii) Separating the food into smaller or thinner portions; (iii) Using rapid cooling equipment; (iv) Stirring the food in a container placed in an ice water bath; (v) Using containers that facilitate heat transfer; (vi) Adding ice as an ingredient; or (vii) Other effective methods. 2. When placed in cooling or cold holding equipment, food containers in which food is being cooled shall be: (i) Arranged in the equipment to provide maximum heat transfer through the container walls; and (ii) Loosely covered or uncovered if protected from overhead contamination during the cooling period to facilitate heat transfer from the surface of the food.

Back door to outside is not self-closing. Make all doors to outside self-closing and ensure they are tight-fitting when shut.

1. Except as specified in paragraphs 2. through 5. of this subsection, outer openings of a food service establishment shall be protected against the entry of insects and rodents by: (i) Filling or closing holes and other gaps along floors, walls, and ceilings; (ii) Closed, tight-fitting windows; and (iii) Solid, self-closing, tight-fitting doors.