Taqueria Del Sol

Observed black mold like residue on the interior walls of the ice machine in the main kitchen. Food contact surfaces must be kept clean in order to prevent contamination. CA pic was advised to clean and sanitize the ice machine as well as to establish a routine cleaning schedule to maintain clean and sanitary conditions.

Observed the accumulation of food debris and grease on the floor in the main kitchen area. All physical facilities must be maintained clean and free of build up. CA advised PIC to clean the affected areas to prevent the accumulation of debris.

Observed several TCS foods in the WIC with internal temps above 41F. (CA) Advised the PIC that TCS foods must be kept at 41F or lower. Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C) or below

Observed multiple TCS food items being held at 43-44 degrees in the WIC. COS- cooler was turned down and food was removed. 511-6-1.04(6)(f) - Time/Temperature Control for Safety; Cold Holding (P) (f) Time/Temperature Control for Safety Food, Hot and Cold Holding. Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C) or below or 135°F (57°C) or above, except that roasts cooked to a temperature and for a time specified in subsection (5)(a)2 of this Rule and reheated using the same temperature and time conditions as cooking may be held at a temperature of 130°F (54°C) or above. P

Observed TPHC being used but log not filled out for today or items marked with the time made or discard time. COS- food was removed. 511-6-1.04(6)(i) - Time as a Public Health Control (TPHC) (P, Pf, C) (i) Time as a Public Health Control.

1. Except as specified under paragraph 4 of this subsection, if time without temperature control is used as the public health control for a working supply of time/temperature control for safety food before cooking, or for ready-to-eat time/temperature control for safety food that is displayed or held for sale or service, written procedures shall be prepared in advance, maintained in the food service establishment, and made available to the regulatory authority upon request that specify: Pf

(i) Methods of compliance with paragraphs 2(i) - (iii) or 3(i) through (v) of this subsection; and

(ii) Methods of compliance with the cooling of time/temperature control for safety food that is prepared, cooked, and refrigerated before time is used as a public health control. Pf

2. If time without temperature control is used as the public health control up to a maximum of 4 hours:

(i) The food shall have an initial temperature of 41°F (5°C) or less when removed from cold holding temperature control, or 135°F (57°C) or greater when removed from hot holding temperature control; P

(ii) The food shall be marked or otherwise identified to indicate the time that is 4 hours past the point in time when the food is removed from temperature control; Pf

(iii) The food shall be cooked and served, served at any temperature if ready-to-eat, or discarded, within 4 hours from the point in time when the food is removed from temperature control; P and

(iv) The food in unmarked containers or packages, or marked to exceed a 4-hour limit shall be discarded. P

3. If time without temperature control is used as the public health control up to a maximum of 6 hours:

(i) The food shall have an initial temperature of 41°F (5°C) or less when removed from temperature control and the food temperature may not exceed 70°F (21°C) within a maximum time period of 6 hours; P

(ii) The food shall be monitored to ensure the warmest portion of the food does not exceed 70°F (21°C) during the 6-hour period, unless an ambient air temperature is maintained that ensures the food does not exceed 70°F (21°C) during the 6-hour holding period; Pf

(iii) The food shall be marked or otherwise identified to indicate: Pf

(I) The time when the food is removed from 41°F (5°C) or less cold holding temperature control, Pf and

(II) The time that is 6 hours past the point in time when the food is removed from cold holding temperature control;

(iv) The food shall be:

(I) Discarded if the temperature of the food exceeds 70°F (21°C), P or

(II) Cooked and served, served at any temperature if ready-to-eat, or discarded within a maximum of 6 hours from the point in time when the food is removed from 41°F (5°C) or less cold holding temperature control; P and

(v) The food in unmarked containers or packages, or marked with a time that exceeds the 6-hour limit shall be discarded. P

4. A food service establishment that serves a highly susceptible population may not use time as the public health control for raw eggs.

Observed a sanitizer bucket concentration exceeding 400ppm. 511-6-1.07(6)(g) - Chemical Sanitizers, Criteria (P) (g) Chemical Sanitizers, Criteria. Chemical sanitizers, including chemical sanitizing solutions generated on-site, and other chemical antimicrobials applied to food-contact surfaces shall:

1. Meet requirements specified in 40 CFR 180.940 Tolerance exemptions for active and inert ingredients for use in antimicrobial formulations (Food-contact surface sanitizing solutions) P, or When ready for use, the end-use concentration of all quaternary chemicals in solution is not to exceed 400 ppm of active quaternary compound. COS- bucket was remade to 200ppm.

Observed two employees in the main cook area with jewelry on their wrist. COS- jewelry was removed. 511-6-1.03(5)(g) - Jewelry (C) (g) Jewelry. Except for a plain ring such as a wedding band food employees may not wear jewelry including medical information jewelry on their arms and hands while preparing food.

Observed a dead roach stuck on the inside of the RIC wall and observed a live bug. CA-observed pest control records from 8/27. Facility is in need of a deep clean. 511-6-1.07(5)(k) - Controlling Pests (Pf, C) (k) Controlling Pests. The presence of insects, rodents, and other pests shall be controlled to minimize their presence on the premises by:

1. Routinely inspecting incoming shipments of food and supplies;

2. Routinely inspecting the premises for evidence of pests;

3. Using methods, if pests are found, such as trapping devices or other means of pest control as specified under subsections (6)(e), (6)(m), and (6)(n) of this Rule; Pf and

4. Eliminating harborage conditions.

Observed visible light coming from the back door. CA- outer openings shall be protected. 511-6-1.07(2)(m) - Outer Openings Protected (C) (m) Outer Openings, Protected.

1. Except as specified in paragraphs 2 through 5 of this subsection, outer openings of a food service establishment shall be protected against the entry of insects and rodents by:

(i) Filling or closing holes and other gaps along floors, walls, and ceilings;

(ii) Closed, tight-fitting windows; and

(iii) Solid, self-closing, tight-fitting doors.

2. The requirements in paragraph 1 of this subsection does not apply if a food service establishment opens into a larger structure, such as a mall, airport, or office building, or into an attached structure, such as a porch, and the outer openings from the larger or attached structure are protected against the entry of insects and rodents.

3. Exterior doors used as exits need not be self-closing if they are:

(i) Solid and tight-fitting;

(ii) Designated for use only when an emergency exists, by the fire protection authority that has jurisdiction over the food establishment; and

(iii) Limited-use so they are not used for entrance or exit from the building for purposes other than the designated emergency exit use.

Observed cutting boards stained and with gashes. CA- cutting boards shall be resurfaced or replaced if they cannot be cleaned. 511-6-1.05(6)(b) - Cutting Surfaces (C) (b) Cutting Surfaces. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced if they can no longer be effectively cleaned and sanitized, or discarded if they cannot be resurfaced.

Observed debris inside the gaskets inside the coolers, observed the WIC fans dusty. CA- nonfood contact surfaces shall be cleaned. 511-6-1.05(7)(a)2,3 - Equipment, Food/Nonfood-Contact Surfaces, and Utensils, food-contact surfaces of cooking equipment & nonfood-contact surfaces free of accumulations (C) 2. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other soil accumulations.

3. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris.

Observed pink and black mold on the baffle of the bulk ice machine. Equipment food-contact surfaces and utensils shall be cleaned: in equipment such as ice bins and beverage dispensing nozzles and enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment. PIC had the ice machine cleaned.

Observed green chili being cooled at room temperature uncovered. Cooling shall be accomplished in accordance with the time and temperature criteria specified under DPH Rule 511-6-1-.04(6)(d) by using one or more of the following methods depending on the type of food being cooled: (i) Placing the food in shallow pans; Pf (ii) Separating the food into smaller or thinner portions; Pf (iii) Using rapid cooling equipment; Pf (iv) Stirring the food in a container placed in an ice water bath; Pf (v) Using containers that facilitate heat transfer; Pf (vi) Adding ice as an ingredient; Pf or (vii) Other effective methods. Pf PIC had the salsa placed in an ice bath.

Observed plastic trays being stored on top of dishes that hold salsa in a reach in cooler. Observed oil being stored directly on the floor in the main kitchen. Except as specified in paragraphs 2 and 3 of this subsection, food shall be protected from contamination by storing the food: (i) In a clean, dry location; (ii) Where it is not exposed to splash, dust, or other contamination; and (iii) At least 6 inches (15 cm) above the floor. PIC had the salsa covered with plastic wrap and the oil picked up.

Observed a sanitizer bucket sanitizing concentration reading 0ppm chlorine or quat. Cloths in-use for wiping counters and other equipment surfaces shall be: (i) Held between uses in a chemical sanitizer solution at a concentration specified under DPH Rule 511-6-1-.05(6)(n); and (ii) Laundered daily. PIC had the sanitizer bucket remade.

Observed several plastic food safe containers and lids either broken, chipped or cracked. PIC had the containers and lids discarded. Multiuse food-contact surfaces shall be: (i) Smooth; Pf (ii) Free of breaks, open seams, cracks, chips, inclusions, pits, and similar imperfections; Pf (iii) Free of sharp internal angles, corners, and crevices; Pf (iv) Finished to have smooth welds and joints; Pf PIC shall purchase new food safe containers.

Observed no sanitizing test strips available for quat ammonium. A test kit or other device that accurately measures the concentration in mg/L of sanitizing solutions shall be provided. Pf PIC shall purchase testing strips for quat sanitizer.

Observed several broken or missing floor tiles in the main kitchen. All physical facilities shall be maintained in good repair. PIC shall have the main kitchen floor tiles repaired or replaced.

Observed several TCS food items being held above 41F in the WIC (see chart below). Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C) or below. PIC had all TCS food items discarded.

Observed pink mold in the ice machine. Equipment food-contact surfaces and utensils shall be cleaned: in equipment such as ice bins and beverage dispensing nozzles and enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment. PIC will have ice machine cleaned.

Observed WIC (46F) and a RIC (51) being held above recommended temperature. Ambient air temperature, water pressure, and water temperature measuring devices shall be maintained in good repair and be accurate within the intended range of use. PIC will have equipment serviced by a licensed professional and show proof of service.

Observed broken gaskets on the WIC and RIC doors. Equipment components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. PIC will have doors repaired.

Observed heavy grease buildup on the hood panels in the main kitchen. Observed buildup on the doors, shelves, and gaskets of reach in coolers. Observed buildup on the shelves and door of the WIC. Observed dust buildup on the vents of the WIC. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other soil accumulations. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. PIC will have these areas cleaned.