Atlanta's Original Uptown Comedy Corner

Observed no Quat sanitizer test strips stored inside the facility to test sanitizer solution. PIC only had chlorine test strips but no more bleach. CA: Advised PIC to obtain Quat test strips and store inside facility. 511-6-1.05(3)(h),(i),(j) - Temperature Measuring Device, Manual Warewashing; Sanitizing Solutions, Testing Device (Pf) (h) Temperature Measuring Devices, Manual and Mechanical Warewashing.

1. In manual warewashing operations, a temperature measuring device shall be provided and readily accessible for frequently measuring the washing and sanitizing temperatures. Pf

2. In hot water mechanical warewashing operations, an irreversible registering temperature indicator shall be provided and readily accessible for measuring the utensil surface temperature. Pf

(i) Sanitizing Solutions, Testing Devices. A test kit or other device that accurately measures the concentration in mg/L of sanitizing solutions shall be provided. Pf

j) Cleaning Agents and Sanitizers.

1. Cleaning agents that are used to clean equipment and utensils as specified under section (7) of this Rule, shall be provided and available for use during all hours of operation. Pf

2. Except for those that are generated on-site at the time of use, chemical sanitizers that are used to sanitize equipment and utensils, as specified under Section (8) of this Rule, shall be provided and available for use during all hours of operation. Pf

Observed a hole in the wall near the back door in main kitchen. Observed several missing ceiling tiles in the back of the main kitchen. CA: Advised PIC to fill in hole and replace ceiling tiles. 511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation.

(a) Good Repair. All physical facilities shall be maintained in good repair.

(b) Cleaning, Frequency and Restrictions.

1. The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products.

2. Except for cleaning that is necessary due to a spill or other accident, cleaning shall be done during periods when the least amount of food is exposed, such as after closing.

3. If present, playground equipment and associated areas shall be maintained in a clean and sanitary condition. In addition, a cleaning and sanitizing plan along with cleaning and sanitizing records for playground equipment and associated areas shall be maintained within the food service establishment for review upon request by the Health Authority. Further, such cleaning and sanitizing plan for employees to follow in the event of encountering vomitus or fecal matter shall be included and submitted at the time of permit application as specified in DPH Rule 511-6-1-.02(1)(c). Pf

Observed the soda nozzles with heavy black buildup. COS- soda nozzles were taken to 3 compartment sink and cleaned. 511-6-1.05(7)(a)1 - Equipment, Food-Contact Surfaces,& Utensils (Pf) (7) Cleaning of Equipment and Utensils.

(a) Equipment, Food-Contact Surfaces, and Utensils.

1. Equipment food-contact surfaces and utensils shall be clean to sight and touch. Pf.

Observed the sanitizer concentration too high at the 3 compartment sink. COS- sink was remade to 50 ppm chlorine. 511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf) (n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows:

1. A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P

Concentration Range Minimum Temperature

MG/L PH 10 or less oF (oC) PH 8 or less oF (oC)

25-49 120 (49) 120 (49)

50-99 100 (38) 75 (24)

100 55 (13) 55 (13)

Observed the restroom doors not self closing and left open. CA- doors shall be able to close. 511-6-1.07(5)(i) - Closing Toilet Room Doors (C) (i) Closing Toilet Room Doors. Except during cleaning and maintenance operations, toilet room doors as specified under subsection (2)(l) of this Rule shall be kept closed.

Observed pink mold like substance inside the interior flap of the ice machine. Ca- ice machine shall be cleaned regularly to prevent buildup. 511-6-1.05(7)(a)1 - Equipment, Food-Contact Surfaces,& Utensils (Pf) (7) Cleaning of Equipment and Utensils.

(a) Equipment, Food-Contact Surfaces, and Utensils.

1. Equipment food-contact surfaces and utensils shall be clean to sight and touch. Pf.

Observed an employee washing a dish without the sanitizer compartment being set up. COS- sink was set up. 511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf) (n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows:

1. A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P

Concentration Range Minimum Temperature

MG/L PH 10 or less oF (oC) PH 8 or less oF (oC)

25-49 120 (49) 120 (49)

50-99 100 (38) 75 (24)

100 55 (13) 55 (13)

Observed a scoop handle down inside flour. COS- handle was put up. Obserevd the ice scoops not stored on a clean surface. 511-6-1.04(4)(k) - In-Use Utensils, Between-Use Storage (C) (k)Storage of In-Use Utensils. During pauses in food preparation or dispensing, food preparation and dispensing utensils shall be stored:

1.Except as specified under paragraph 2 of this subsection, in the food with their handles above the top of the food and the container;

2.In food that is not time/temperature control for safety food with their handles above the top of the food within containers or equipment that can be closed, such as bins of sugar, flour, or cinnamon;

3.On a clean portion of the food preparation table or cooking equipment only if the in-use utensil and the food-contact surface of the food preparation table or cooking equipment are cleaned and sanitized at a frequency specified under DPH Rule 511-6-1-.05(7)(b) and (8)(a);

4.In running water of sufficient velocity to flush particulates to the drain, if used with moist food such as ice cream or mashed potatoes;

5. In a clean, protected location if the utensils, such as ice scoops, are used only with a food that is not time/temperature control for safety food; or

6. In a container of water if the water is maintained at a temperature of at least 135°F (57°C) and the container is cleaned at a frequency specified under DPH Rule 511-6-1-.05(7)(b)3(vi).

Observed no test strips for employees to check the sanitizer concentration. CA- test strips shall be provided. 511-6-1.05(3)(h),(i) - Temperature Measuring Device, Manual Warewashing; Sanitizing Solutions, Testing Device (Pf) (h) Temperature Measuring Devices, Manual and Mechanical Warewashing.(i) Sanitizing Solutions, Testing Devices. A test kit or other device that accurately measures the concentration in mg/L of sanitizing solutions shall be provided. Pf

Observed buildup on the outside of equipment throughout the main kitchen. CA- all nonfood contact surfaces shall be kept clean. Observed standing water in the bar RIC. 511-6-1.05(7)(a)2,3 - Equipment, Food/Nonfood-Contact Surfaces, and Utensils, food-contact surfaces of cooking equipment & nonfood-contact surfaces free of accumulations (C) 2. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other soil accumulations.

3. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris.

Observed the restroom doors not self closing and left open. CA- doors shall be able to close. 511-6-1.07(5)(i) - Closing Toilet Room Doors (C) (i) Closing Toilet Room Doors. Except during cleaning and maintenance operations, toilet room doors as specified under subsection (2)(l) of this Rule shall be kept closed.

Observed the floors throughout the kitchen unclean. CA- floors shall be kept clean. 511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation.

(a) Good Repair. All physical facilities shall be maintained in good repair.

(b) Cleaning, Frequency and Restrictions.

1. The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products.

Observed a light missing over the vent hood. CA- light shall be replaced. 511-6-1.07(2)(i) - Light Bulbs, Protective Shielding (C) (i) Light Bulbs, Protective Shielding.

1. Except as specified in paragraph 2 of this subsection, light bulbs shall be shielded, coated, or otherwise shatter-resistant in areas where there is exposed food; clean equipment, utensils, and linens; or unwrapped single-service and single-use articles.

2. Shielded, coated, or otherwise shatter-resistant bulbs need not be used in areas used only for storing food in unopened packages, if:

(i) The integrity of the packages cannot be affected by broken glass falling onto them; and

(ii) The packages are capable of being cleaned of debris from broken bulbs before the packages are opened.

3. An infrared or other heat lamp shall be protected against breakage by a shield surrounding and extending beyond the bulb so that only the face of the bulb is exposed.