Oakwood, Hall County

HAYDEE'S CAFE

3204 ATLANTA HWY GAINESVILLE, GA 30507

Food
Latest score
80
Jan 2, 2026
City
Oakwood
County
Hall
Inspections
5

Score history

Inspection scores over time for this facility.

Inspection history

Georgia inspection history is score-based, with violations grouped under each recorded inspection.

Jan 2, 2026

Routine

Score: 804 violations

6-1A - proper cold holding temperatures

Regulation: 511-6-1.04(6)(f) - time/temperature control for safety; cold holding (p)

9 ptsCorrected: YesRepeat: Yes

Observed chorizo, and raw scrambled eggs, sitting by the grill to have a temperature of 67F. Also observed several food items (check temperature log), in/under the prep-top cooler to have temperatures above 41F. Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C). COS: All food items were voluntarily disposed of by the owner. EHS discussed time as a public health control or using an ice bath to ensure that all food items can stay in proper temperature.

4-2B - food-contact surfaces: cleaned & sanitized

Regulation: 511-6-1.05(6)(n) - manual and mechanical warewashing equipment, chemical sanitization-temperature, ph, concentration, hardness (p,pf)

4 ptsCorrected: YesRepeat: No

Observed the ware-wash machine to not be in proper working order when dispensing the chlorine sanitizer. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times should have a concentration between 50-100ppm when testing with testing kit. COS: PIC set up the 3-compartment sink to manually wash the utensils and equipment. PIC contacted the manufacturer, during the inspection, to place a work order.

11A - proper cooling methods used: adequate equipment for temperature control

Regulation: 511-6-1.04(6)(e) - cooling methods (pf, c)

3 ptsCorrected: YesRepeat: No

Observed several pans of diced tomatoes to be cooling while fully covered. Cooling shall be accomplished in accordance with the time and temperature criteria specified under DPH Rule 511-6-1-.04(6)(d) by using one or more of the following methods depending on the type of food being cooled:

(i) Placing the food in shallow pans; Pf

(ii) Separating the food into smaller or thinner portions; Pf

(iii) Using rapid cooling equipment; Pf

(iv) Stirring the food in a container placed in an ice water bath; Pf

(v) Using containers that facilitate heat transfer; Pf

(vi) Adding ice as an ingredient; Pf or

(vii) Other effective methods. Pf

  1. When placed in cooling or cold holding equipment, food containers in which food is being cooled shall be:

(i) Arranged in the equipment to provide maximum heat transfer through the container walls; and

(ii) Loosely covered, or uncovered if protected from overhead contamination during the cooling period to facilitate heat transfer from the surface of the food.

COS: PIC voluntarily uncovered all pans to ensure that cooling would properly occur.

15B - warewashing facilities: installed, maintained, used; test strips

Regulation: 511-6-1.05(3)(h),(i),(j) - temperature measuring device, manual warewashing; sanitizing solutions, testing device (pf)

1 ptsCorrected: YesRepeat: Yes

Observed food service establishment to not have any test strips for the QAC sanitizer or for the Chlorine in the ware-wash machine. Sanitizing Solutions, Testing Devices. A test kit or other device that accurately measures the concentration in mg/L of sanitizing solutions shall be provided. PIC ordered test strips during the inspection.

May 5, 2025

Routine

Score: 854 violations

6-1A - proper cold holding temperatures

Regulation: 511-6-1.04(6)(f) - time/temperature control for safety; cold holding (p)

9 ptsCorrected: YesRepeat: No

Observed chorizo sitting by the grill to have a temperature of 67F. Also observed several food items (check temperature log), in/under the prep-top cooler to have temperatures above 41F. Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C). COS: All food items were voluntarily disposed of by the owner. EHS discussed time as a public health control or using an ice bath to ensure that all food items can stay in proper temperature.

1-2B - certified food protection manager

Regulation: 511-6-1.03(3)(c) - certification documentation (pf)

4 ptsCorrected: NoRepeat: No

Observed expired CSFM certificate posted in the food service establishment 11/7/24. A CSFM certificate which has expired, been revoked or suspended shall not be posted in the food service establishment. All licenses, certificates, diplomas, or other similar credentials issued or granted to an owner or operator who has successfully completed an approved or accredited food safety certification course and exam shall expire on the expiration date determined by the credentialing organization. Within 90 days of expiration of the CSFM certificate, the CSFM shall enroll in an approved food safety training course, pass an approved exam, and obtain a new certificate. PIC stated he contacted a proctor, to schedule the exam, during the inspection.

15B - warewashing facilities: installed, maintained, used; test strips

Regulation: 511-6-1.05(3)(h),(i),(j) - temperature measuring device, manual warewashing; sanitizing solutions, testing device (pf)

1 ptsCorrected: NoRepeat: No

Observed food service establishment to not have any test strips for the QAC sanitizer or for the Chlorine in the ware-wash machine. Sanitizing Solutions, Testing Devices. A test kit or other device that accurately measures the concentration in mg/L of sanitizing solutions shall be provided. PIC ordered test strips during the inspection.

17D - adequate ventilation and lighting; designated areas used

Regulation: 511-6-1.07(4)(b) - designated areas for employee activity, located to prevent contamination of food, equipment, utensils, linens, & single service articles (c)

1 ptsCorrected: YesRepeat: No

Observed a drinking cup sitting on the prep table while food was being prepped. Also observed a drinking cup being stored underneath the prep-top cooler. Areas designated for employees to eat, drink, use tobacco products and electronic devices shall be located so that food, equipment, linens, and single-service and single-use articles are protected from contamination. COS: PIC voluntarily removed cups during the inspection.

Oct 3, 2024

Routine

Score: 913 violations

4-2B - food-contact surfaces: cleaned & sanitized

Regulation: 511-6-1.05(6)(n) - manual and mechanical warewashing equipment, chemical sanitization-temperature, ph, concentration, hardness (p,pf)

4 ptsCorrected: YesRepeat: No

Observed the sanitizer water to be at 110F.

A quaternary ammonium compound solution shall have a minimum temperature of 75ºF (24ºC), P have a concentration as specified in DPH Rule 511-6-1-.07(6)(g) and as indicated by the manufacturer’s use directions included in the labeling, P and be used only in water with 500 ppm hardness or less or in water having a hardness no greater than specified by the EPA-registered label use instructions.

Note: PIC voluntarily remade sanitizer solution which was tested to be at 200-400ppm. The temperature was taken and temped to be 75F.

12B - personal cleanliness

Regulation: 511-6-1.03(5)(g) - jewelry (c)

3 ptsCorrected: YesRepeat: Yes

Observed several food employees to be wearing bracelets while prepping food.

Jewelry. Except for a plain ring such as a wedding band food employees may not wear jewelry including medical information jewelry on their arms and hands while preparing food.

Note: PIC voluntarily instructed both food employees to remove the bracelets from wrist during the inspection.

14B - utensils, equipment and linens: properly stored, dried, handled

Regulation: 511-6-1.05(10)(e)1,2,4 - equipment, utensil, linens, stored 6" off floor in clean, dry location (c)

1 ptsCorrected: YesRepeat: No

Observed several food containers to be stored facing up.

In a self-draining position that allows air drying; and

(ii) Covered or inverted.

Note: PIC voluntarily instructed employees to store food containers and equipment in an inverted position.

Mar 19, 2024

Routine

Score: 972 violations

12B - personal cleanliness

Regulation: 511-6-1.03(5)(g) - jewelry (c)

3 ptsCorrected: YesRepeat: No

Observed one employee wearing a ring while actively preparing food. Except for a plain ring such as a wedding band food employees may not wear jewelry including medical information jewelry on their arms and hands while preparing food. COS: Employee voluntarily removed ring during inspection.

12B - personal cleanliness

Regulation: 511-6-1.03(5)(j) - hair restraints (c)

3 ptsCorrected: YesRepeat: No

Observed an employee to not have on an approved form of hair restraint, while actively preparing food. Employees preparing or handling food shall use effective and clean, disposable or easily cleanable nets or other hair restraints approved by the Health Authority, worn properly to restrain loose hair including beards and mustaches longer than one half inch. COS: Employee voluntarily placed a hairnet on during the inspection.

Sep 19, 2023

Routine

Score: 962 violations

4-2B - food-contact surfaces: cleaned & sanitized

Regulation: 511-6-1.05(7)(b) - food contact surfaces and utensils - cleaning frequency (p, c)

4 ptsCorrected: NoRepeat: No

511-6-1.05(7)(b) - Food Contact Surfaces and Utensils - Cleaning Frequency (P, C)iv) In equipment such as ice bins and beverage dispensing nozzles and enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment:

(I) At a frequency specified by the manufacturer; or

(II) Absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. Note: Inspector observed accumulated mold debris inside the ice making machine. All food contact surfaces should be clean to sight and touch. Manager will clean the ice machine at the end of the day. New Violation.

4-2B - food-contact surfaces: cleaned & sanitized

Regulation: 511-6-1.05(6)(n) - manual and mechanical warewashing equipment, chemical sanitization-temperature, ph, concentration, hardness (p,pf)

4 ptsCorrected: NoRepeat: No

511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf). According to regulations chlorine sanitizer should have a concentration of 50-100ppm to adequately sanitize. Note: Inspector observed chlorine concentration of mechanical warewashing machine at 0ppm. PIC stated the were going to put a service request in by end of day.