Johnny's New York Style Pizza

Observed interior of dish machine with black accumulation.511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf) (n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows:

1. A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P

Concentration Range Minimum Temperature

MG/L PH 10 or less oF (oC) PH 8 or less oF (oC)

25-49 120 (49) 120 (49)

50-99 100 (38) 75 (24)

100 55 (13) 55 (13)

2. An iodine solution shall have a minimum temperature of 68°F (20°C)P minimum concentration between 12.5 ppm and 25 ppm, P and pH of 5.0 or less or a pH no higher than the level for which the manufacturer specifies for the solution to be effective; P

3. A quaternary ammonium compound solution shall have a minimum temperature of 75ºF (24ºC), P have a concentration as specified in DPH Rule 511-6-1-.07(6)(g) and as indicated by the manufacturer’s use directions included in the labeling, P and be used only in water with 500 ppm hardness or less or in water having a hardness no greater than specified by the EPA-registered label use instructions; P

4. If another solution of a chemical specified under paragraphs 1 through 3 of this subsection is used, the permit holder shall demonstrate to the Health Authority that the solution achieves sanitization and the use of the solution shall be approved; P

5. If a chemical sanitizer other than chlorine, iodine, or a quaternary ammonium compound is used, it shall be applied in accordance with the EPA-registered label use instructions ;P and

6. If a chemical sanitizer is generated by a device located on-site at the food service establishment, it shall be used as specified in 1-5 of this subsection and shall be produced by a device that:

(i) complies with law as specified in sections 2(q)(1) and 12 of the Federal Insecticide, Fungicide, and Rodenticide Act (FIFRA), P

(ii) complies with 40 CFR 152.500 Requirement for Devices and 40 CFR 156.10 Labeling Requirements, P

(iii) displays the EPA device manufacturing facility registration number on the device, Pf and

(iv) is operated and maintained in accordance with manufacturer’s instructions. Pf.

7. On-site chemical sanitizer generating equipment with active ingredients, such as copper, must be registered as pesticides. The active ingredient may be part of the equipment or separately added.

Observed wiping cloths stored in a sanitizer solution of 0 ppm. Wet wiping cloths must be stored in a sanitizer solution between use. 511-6-1.04(4)(m) - Wiping Cloths, Use Limitation (C) (m) Wiping Cloths, Use Limitation.

1. Cloths in-use for wiping food spills from tableware and carry-out containers that occur as food is being served shall be:

(i) Maintained dry; and

(ii) Used for no other purpose.

2. Cloths in-use for wiping counters and other equipment surfaces shall be:

(i) Held between uses in a chemical sanitizer solution at a concentration specified under DPH Rule 511-6-1-.05(6)(n); and

(ii) Laundered daily.

3. Cloths in-use for wiping surfaces in contact with raw animal foods shall be kept separate from cloths used for other purposes.

4. Dry wiping cloths and the chemical sanitizing solutions in which wet wiping cloths are held between uses shall be free of food debris and visible soil.

5. Containers of chemical sanitizing solutions in which wet wiping cloths are held between uses shall be stored off the floor and used in a manner that prevents contamination of food, equipment, utensils, linens, single-service, or single-use articles.

6. Single-use disposable sanitizer wipes shall be used in accordance with EPA-approved manufacturer’s label use instructions.

Observed excessive staining and scratches on prep top cutting boards. Manager was advised to resurface cutting board or replaced if unable to be resurfaced. 511-6-1.05(6)(b) - Cutting Surfaces (C) (b) Cutting Surfaces. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced if they can no longer be effectively cleaned and sanitized, or discarded if they cannot be resurfaced.

Observed excessive dust and black accumulation on shelving unit above oven and dust accumulation on shelving units throughout the facility. 511-6-1.05(7)(a)2,3 - Equipment, Food/Nonfood-Contact Surfaces, and Utensils, food-contact surfaces of cooking equipment & nonfood-contact surfaces free of accumulations (C) 2. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other soil accumulations.

3. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris.

Observed floors in disrepair or not properly sealed within the main kitchen and baseboard missing under 3-compartment sink. Please, retile, and/ or repaint. 511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation.

(a) Good Repair. All physical facilities shall be maintained in good repair.

(b) Cleaning, Frequency and Restrictions.

1. The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products.

2. Except for cleaning that is necessary due to a spill or other accident, cleaning shall be done during periods when the least amount of food is exposed, such as after closing.

Observed food items in reach-in cooler adjacent to salad prep area above 41F. Manager disposed of out of temperature items. 511-6-1.04(6)(f) - Time/Temperature Control for Safety; Cold Holding (P) (f) Time/Temperature Control for Safety Food, Hot and Cold Holding. Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C) or below or 135°F (57°C) or above, except that roasts cooked to a temperature and for a time specified in subsection (5)(a)2 of this Rule and reheated using the same temperature and time conditions as cooking may be held at a temperature of 130°F (54°C) or above. P

Observed facility with no test strips for quaternary ammonium sanitizer solution.

Observed black mold-like accumulation on wall behind dish machine, floors in disrepair or not properly sealed. Please seal, retile, and/ or repaint floors. 511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation.

(a) Good Repair. All physical facilities shall be maintained in good repair.

(b) Cleaning, Frequency and Restrictions.

1. The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products.

2. Except for cleaning that is necessary due to a spill or other accident, cleaning shall be done during periods when the least amount of food is exposed, such as after closing.

3. If present, playground equipment and associated areas shall be maintained in a clean and sanitary condition. In addition, a cleaning and sanitizing plan along with cleaning and sanitizing records for playground equipment and associated areas shall be maintained within the food service establishment for review upon request by the Health Authority. Further, such cleaning and sanitizing plan for employees to follow in the event of encountering vomitus or fecal matter shall be included and submitted at the time of permit application as specified in DPH Rule 511-6-1-.02(1)(c). Pf

Observed three pizzas stored on a pizza rack for TPHC without overhead protection. Manager corrected o site. Observed reach in cooler next to the salad prep cooler with deli meats stored uncovered.

Observed dishwashing machine interior with black build up.

Observed food employees preparing food without proper hair restraints.

511-6-1.03(5)(i) - Hair Restraints (C) (i) Hair Restraints.

1. Employees preparing or handling food shall use effective and clean, disposable or easily cleanable nets or other hair restraints approved by the Health Authority, worn properly to restrain loose hair including beards and mustaches longer than one half inch.

Observed food debris and rust on the walk in cooler shelves. Manager was advised to clean, paint and seal the shelves in the cooler.

Observed black build up on the walls behind the dishwashing machine. Observed baseboards missing underneath the ware washing area.

Observed debris on plates stored above the prep top cooler. Manager inverted the plates and removed dirty plates.

Also observed black/brown substance on wall of ice machine.

Observed dishes not inverted or covered above prep cooler.

Observed door of walk-in cooler not properly closing and in disrepair.

Observed excessive dust accumulation on shelving beside ovens.

Observed employee belongings on prep area in main kitchen.

Food items in prep top cooler and connecting reach in cooler cold held above 41F. IC put ice on items (COS).

Observed cutting board with deep cuts and old food within the cuts. Dishwashing machine with calcium build up on interior surfaces.

Observed an oil like and white substance without a common food name label.

Observed multiple RTE and TCS food items stored among multiple prep top coolers and reach in coolers found out of temperature (greater than 41F). COS: PIC placed items prepared today on ice bath for rapid cooling method.

Observed equipment for holding cold food not sufficient in capacity or operation to provide food temperatures specified under 511-6-1 .04(6)(f).