DECO AT 5211 (POOL)

Observed low turnover rate of 90gpm. CPO stated that the flow meter is showing a combined turnover rate for both pools. Therefore, both pools must have a combined turnover rate of 188gpm.

13-190(a): The equipment shall be operated continuously on a twenty-four (24) hour basis to obtain the minimum required number of four (4) turnovers per day, or one turnover every six (6) hours.

Observed low turnover rate of 100gpm. CPO stated that the flow meter is showing a combined turnover rate for both pools. Therefore, both pools must have a combined turnover rate of 188gpm.

13-190(a): The equipment shall be operated continuously on a twenty-four (24) hour basis to obtain the minimum required number of four (4) turnovers per day, or one turnover every six (6) hours.

Observed FCL reading of 14+ ppm which exceeds the 10ppm requirement.

CA: 13-189(c)(1)Where stabilizing agents are used, a free-chlorine residual shall be maintained at a concentration of no less than three parts per million (3ppm) at all times. The maximum stabilized or unstabilized free chlorine residual shall not exceed ten parts per million (10ppm).

Discussed with CPO to lower the FCL levels in the pool. CPO will be draining some of the water, then refilling the pool and servicing it to achieve proper FCL levels.

An observed turnover rate of 0 GPM was recorded. A 36,000-gallon pool must have a minimum turnover rate of 100 GPM.

CA: 13-190(a) The equipment shall be operated continuously on a twenty-four (24) hour basis to obtain the minimum required number of four (4) turnovers per day, or one turnover every six (6) hours.

13-190(a) The equipment shall be operated continuously on a twenty four hour basis to obtain the minimum required number of four turnovers per day, or one every six hours. Flow meter was not operational.

13-190(a) Minimum required turnover rate every 30 mins for spas. CPO stated that the flow meter shows the combined GPM for both pools. Required GPM is 154 gpm and the current gpm is at 90 gpm. Please correct to adequate turnover rate.

13-189(c)(1) FCL shall be maintained between 3-10ppm at all times. Observation: Initial reading 2.35, second reading 3ppm.

13-190(a) Minimum required turnover rate every 30 mins for spas. CPO stated that the flow meter shows the combined GPM for both pools. Required GPM is 154 gpm and the current gpm is at 92 gpm. Please correct to adequate turnover rate.

13-189(c)(2) Cyanuric acid levels shall not exceed 100ppm. Observed cyanuric acid at 175ppm COS: Cyanuric acid corrected to read at

13-190(a) Minimum required turnover rate every 30 mins for spas. CPO stated that the flow meter shows the combined GPM for both pools. Required GPM is 131 gpm and the current gpm is at 92 gpm. Please correct to adequate turnover rate.

13-201 (b) - Observed deck shower not functional; please repair.