Up On The Roof Kitchen

Observed several cutting boards that had heavy scoring under prep table next to the walk in fridge.

Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced if they can no longer be effectively cleaned and sanitized, or discarded if they cannot be resurfaced.

PIC discarded the cutting boards.

Observed a broken gauge for the dishwasher in the kitchen on the right of the handsink under the drain board for the 3C sink. A warewashing machine shall be equipped with a temperature measuring device that indicates the temperature of the water:

1. In each wash and rinse tank; Pf and

2. As the water enters the hot water sanitizing final rinse manifold or in the chemical sanitizing solution tank. Pf PIC will contact their vendor to service the dishwasher gauge.

Observed a pink mold like substance on the baffle of the ice machine. 5. Except when dry cleaning methods are used as specified under subsection (7)(e) of this Rule, surfaces of utensils and equipment contacting food that is not time/temperature control for safety food shall be cleaned:

(i) At any time when contamination may have occurred;

(ii) At least every 24 hours for iced tea dispensers including nozzles and consumer self-service utensils such as tongs, scoops, or ladles;

(iii) Before restocking consumer self-service equipment and utensils such as condiment dispensers and display containers; and

(iv) In equipment such as ice bins and beverage dispensing nozzles and enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment:

(I) At a frequency specified by the manufacturer; or

(II) Absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. PIC discard or burn all the ice and have the machine cleaned and sanitized with bleach.

Observed house flies in the upstairs kitchen area and fruit flies at the bar area around the dump sink and hand sink.

The presence of insects, rodents, and other pests shall be controlled to minimize their presence on the premises by:

1. Routinely inspecting incoming shipments of food and supplies;

2. Routinely inspecting the premises for evidence of pests;

3. Using methods, if pests are found, such as trapping devices or other means of pest control as specified under subsections (6)(e), (6)(m), and (6)(n) of this Rule; Pf and

4. Eliminating harborage conditions.

PIC will contact their vendor to service the

Observed 00 ppm from the sanitizer line at the 3C sink. The recommended range is 150 - 400 ppm. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows: 3. A quaternary ammonium compound solution shall have a minimum temperature of 75ºF (24ºC), P have a concentration as specified in DPH Rule 511-6-1-.07(6)(g) and as indicated by the manufacturer’s use directions included in the labeling, P and be used only in water with 500 ppm hardness or less or in water having a hardness no greater than specified by the EPA-registered label use instructions; PIC will contact his vendor to service the sanitizer line.

Observed several heavily scored cutting boards on the PTC and under one of the prep tables.

1. Equipment food-contact surfaces and utensils shall be clean to sight and touch. Pf. PIC will discard and replace the cutting boards throughout the facility.

Observed out of date items that were still present in the WIC during the inspection. the item were several containers of burrata cheese w/ a use by date of 09/20/23 and gochujang sauce date marked 10/06. 2. Except as specified in paragraphs 4 through 6 of this subsection, refrigerated, ready-to-eat, time/temperature control for safety food prepared and packaged by a food processing plant shall be clearly marked, at the time the original container is opened in a food service establishment and if the food is held for more than 24 hours, to indicate the date or day by which the food shall be consumed on the premises, sold, or discarded, when held at a temperature of 41°F (5°C) or below for a maximum of 7 days after the original container is opened. The day the original container is opened in the food service establishment shall be counted as Day 1, except, the day or date marked by the food service establishment may not exceed a manufacturer’s use by date if the manufacturer determined the use-by date based on food safety; Pf PIC will discard these items.

Observed a broken light underneath hood in the kitchen. 3. At least 50 foot candles (540 lux) at a surface where a food service employee is working with food or working with utensils or equipment such as knives, slicers, grinders, or saws where employee safety is a factor. PIC will have the light replaced.