Subway #62586

Observed containers holding bleach and bottles of pine-sol stored next to Gatorade and juice beverage bottles underneath shelf, next to mop sink area in kitchen. Operator removed all chemicals and properly stored away from beverages during inspection. 511-6-1.07(6)(c) - Storage, Separation (P) (c) Storage, Separation. Poisonous or toxic materials shall be stored so they cannot contaminate food, equipment, utensils, linens, and single-service and single-use articles by:

1. Separating the poisonous or toxic materials by spacing or partitioning; P and

2. Locating the poisonous or toxic materials in an area that is not above food, equipment, utensils, linens, and single-service or single-use articles. This requirement does not apply to equipment and utensil cleaners and sanitizers that are stored in warewashing areas for availability and convenience if the materials are stored to prevent contamination of food, equipment, utensils, linens, and single-service and single-use articles. P

Observed multiple hotel pans stacked tightly unable to properly dry on shelf above three compartment sink in kitchen. Operator separated pans to adequately dry during inspection. 511-6-1.05(10)(a) - Equipment & Utensils, Air-Drying Required (C) (10) Protection of Clean Items.

(a) Equipment and Utensils, Air-Drying Required. After cleaning and sanitizing, equipment and utensils:

1. Shall be air-dried or used after adequate draining before contact with food; and

2. May not be cloth dried except that utensils that have been air-dried may be polished with cloths that are maintained clean and dry.

Observed potentially hazardous food (chicken and roast beef) cold held at greater than 41 degrees Fahrenheit inside the reach in cooler behind front counter. COS. Foods discarded by manager. Do not use Reach in cooler unit it is repaired. CA: Repair within 10 days.

511-6-1.04(6)(f) - Time/Temperature Control for Safety; Cold Holding (P) (f) Time/Temperature Control for Safety Food, Hot and Cold Holding. Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C) or below

Observed no air thermometer inside the reach in cold holding unit on front line. CA: Manager shall provide an air thermometer inside all cold holding units.

511-6-1.05(2)(x) - TMD, Located in Refrigerators/ Hot Holding (Pf, C) (x) Temperature Measuring Devices.

1. In a mechanically refrigerated or hot food storage unit, the sensor of a temperature measuring device shall be located to measure the air temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot food storage unit

Observed leaking pipe under the 3 compartment sink (under wash compartment). CA: shall repair within 10 days.

Observed Vacuum breaker in dis-repair. Shall repair within 10 days.

511-6-1.06(2)(e) - Backflow Prevention Device, Design Standard (P) (e) Backflow Prevention Device, Design Standard. A backflow or backsiphonage prevention device installed on a water supply system shall meet American Society of Sanitary Engineering (A.S.S.E.) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device

Observed equipment and/or utensils are not being air-dried or adequately drained after cleaning and sanitizing them before using them in contact with food. CA: CFSM must allow for the equipment/dishes to air dry before staking the dishes away.

511-6-1.05(10)(a) - Equipment & Utensils, Air-Drying Required (C) (10) Protection of Clean Items.

(a) Equipment and Utensils, Air-Drying Required. After cleaning and sanitizing, equipment and utensils:

1. Shall be air-dried or used after adequate draining before contact with food; and

2. May not be cloth dried except that utensils that have been air-dried may be polished with cloths that are maintained clean and dry.

Observed reach in cooler not working properly. COS: Manager discarded meats found out of temperature and removed all other items (peppers, and pickles) from cooler. CA: shall repair reach in cooler before placing food inside.

511-6-1.05(6)(q)1&3 - Good Repair & Calibration (C) (q) Good Repair and Calibration.

1. Utensils shall be maintained in a state of repair or condition that complies with the requirements specified under subsections (1) and (2) of this Rule or shall be discarded.
2. Ambient air temperature, water pressure, and water temperature measuring devices shall be maintained in good repair and be accurate within the intended range of use.

Observed chocolate chip cookies stored on rack uncovered where plastic wear, etc is stored. Ca: food shall be protected from contamination.

511-6-1.04(4)(q) - Food Storage (C) (q) Food Storage.

1. Except as specified in paragraphs 2 and 3 of this subsection, food shall be protected from contamination by storing the food:

(i) In a clean, dry location;

(ii) Where it is not exposed to splash, dust, or other contamination; and

(iii) At least 6 inches (15 cm) above the floor.

2. Food in packages and working containers may be stored less than 6 inches (15 cm) above the floor on case lot handling equipment if the equipment can be moved by hand or by conveniently available apparatuses such as hand trucks and forklifts.

Observed faucet at hand sink in main kitchen coming off, in need of repair. Ca: system shall be maintained in good repair.

511-6-1.06(2)(r) - System Maintained in Good Repair (P, C) (r) System Maintained in Good Repair. A plumbing system shall be repaired according to law; P and maintained in good repair.

Observed several items in WIC being held longer than 24 hours without proper date marking. Ca: items held longer than 24 hours must have proper date marking.

511-6-1.04(6)(g) - Ready-To-Eat Time/Temperature Control for Safety Food, Date Marking (Pf) (g) Ready-to-Eat Time/Temperature Control for Safety Food, Date Marking

1. Except when packaging food using a reduced oxygen packaging method, and except as specified in paragraphs 4 and 5 of this subsection, refrigerated, ready-to-eat, time/temperature control for safety food prepared and held in a food establishment for more than 24 hours shall be clearly marked to indicate the date or day by which the food shall be consumed on the premises, sold, or discarded, when held at a temperature of 41°F (5°C) or below for a maximum of 7 days. The day of preparation shall be counted as Day 1. Pf

2. Except as specified in paragraphs 4 through 6 of this subsection, refrigerated, ready-to-eat, time/temperature control for safety food prepared and packaged by a food processing plant shall be clearly marked, at the time the original container is opened in a food service establishment and if the food is held for more than 24 hours, to indicate the date or day by which the food shall be consumed on the premises, sold, or discarded, when held at a temperature of 41°F (5°C) or below for a maximum of 7 days after the original container is opened. The day the original container is opened in the food service establishment shall be counted as Day 1, except, the day or date marked by the food service establishment may not exceed a manufacturer’s use by date if the manufacturer determined the use-by date based on food safety; Pf

3. A refrigerated, ready-to-eat, time/temperature control for safety food ingredient or a portion of a refrigerated, ready-to-eat, time/temperature control for safety food that is subsequently combined with additional ingredients or portions of food shall retain the date marking of the earliest-prepared or first-prepared ingredient. Pf

4. A date marking system that meets the criteria stated in paragraphs 1 and 2 of this subsection may include:

(i) Using a method approved by the Health Authority for refrigerated, ready-to-eat time / temperature control for safety food that is frequently rewrapped, such as lunchmeat or a roast, or for which date marking is impractical, such as soft serve mix or milk in a dispensing machine;

(ii) Marking the date or day of preparation, with a procedure to discard the food on or before the last date or day by which the food must be consumed on the premises, sold, or discarded;

(iii) Marking the date or day the original container is opened in a food service establishment, with a procedure to discard the food on or before the last date or day by which the food must be consumed on the premises, sold, or discarded; or

(iv) Using calendar dates, days of the week, color-coded marks, or other effective marking methods, provided that the marking system is disclosed to the Health Authority upon request.

Observed tuna made on 6/6/2023 at 9:24am at 50 degrees in the WIC. COS- tuna was discarded. 511-6-1.04(6)(d) - Cooling (P) (d) Cooling.

1. Cooked time/temperature control for safety food shall be cooled:

(i) Within 2 hours from 135°F (57°C) to 70°F (21°C); P and

(ii) Within a total of 6 hours from 135°F (57°C) to 41°F (5°C) or less. P

2. Time/temperature control for safety food shall be cooled within 4 hours to 41°F (5°C) or less if prepared from ingredients at ambient temperature, such as reconstituted foods and canned tuna. P