Gainesville, Hall County

PEYTONS PIE COMPANY-GAINESVILLE

118 MAIN ST STE E GAINESVILLE, GA 30501

Food
Latest score
99
Mar 5, 2026
City
Gainesville
County
Hall
Inspections
5

Score history

Inspection scores over time for this facility.

Inspection history

Georgia inspection history is score-based, with violations grouped under each recorded inspection.

Mar 5, 2026

Routine

Score: 991 violation

14C - single-use/single-service articles: properly stored, used

Regulation: 511-6-1.05(10)(g)(1)&(3) - kitchenware and tableware, single-service/-use items properly handled to protect food-/lip-contact surfaces (c)

1 ptsCorrected: YesRepeat: No

Single service spoons, knives and forks observed at customer self serving area not cwrapped to prevent contamination. 511-6-1.05(10)(g)(1)&(3) - Kitchenware and Tableware, Single-service/-use items properly handled to protect food-/lip-contact surfaces (C) (g) Kitchenware and Tableware.

  1. Single-service and single-use articles and cleaned and sanitized utensils shall be handled, displayed, and dispensed so that contamination of food-and lip-contact surfaces is prevented.
  2. Except as specified under paragraph 2 of this subsection, single-service articles that are intended for food- or lip-contact shall be furnished for consumer self-service with the original individual wrapper intact or from an approved dispenser. Note: Manager removed all the utensils during the inspection.

Sep 22, 2025

Routine

Score: 961 violation

4-2B - food-contact surfaces: cleaned & sanitized

Regulation: 511-6-1.05(7)(a)1 - equipment, food-contact surfaces,& utensils (pf)

4 ptsCorrected: YesRepeat: No

Observed encrusted material on can opener blade.

Equipment, Food-Contact Surfaces,& Utensils (Pf) (7) Cleaning of Equipment and Utensils.

(a) Equipment, Food-Contact Surfaces, and Utensils.

  1. Equipment food-contact surfaces and utensils shall be clean to sight and touch. Pf.

COS: PIC cleaned can opener blade during inspection.

Dec 17, 2024

Routine

Score: 952 violations

12C - wiping cloths: properly used and stored

Regulation: 511-6-1.04(4)(m) - wiping cloths, use limitation (c)

3 ptsCorrected: YesRepeat: No

Wiping clothes were observed not stored in Sanitizer solution in between tasks. (i) Held between uses in a chemical sanitizer solution at a concentration specified under DPH Rule 511-6-1-.05(6)(n); and

(ii) Laundered daily.

  1. Cloths in-use for wiping surfaces in contact with raw animal foods shall be kept separate from cloths used for other purposes.

  2. Dry wiping cloths and the chemical sanitizing solutions in which wet wiping cloths are held between uses shall be free of food debris and visible soil. Note: The Manager placed the wiping clothes in Quaternary Ammonium sanitizer during the inspection.

17D - adequate ventilation and lighting; designated areas used

Regulation: 511-6-1.07(3)(f) - lighting intensity, adequate in food prep, storage & service areas (c)

1 ptsCorrected: NoRepeat: Yes

The light fixture inside the walk in refrigeration unit was not working, no light was observed inside the unit.
511-6-1.07(3)(f) - Lighting Intensity, adequate in food prep, storage & service areas (C) (f) Lighting Intensity. The light intensity shall be:

  1. At least 10 foot candles (108 lux) at a distance of 30 inches (75 cm) above the floor, in walk-in refrigeration units and dry food storage areas and in other areas and rooms during periods of cleaning.

Jun 12, 2024

Routine

Score: 973 violations

16B - plumbing installed; proper backflow devices

Regulation: 511-6-1.06(2)(d) - backflow prevention, air gap (p)

2 ptsCorrected: NoRepeat: No

The facility's vegetable prep sink and (3) Compartment sink were both observed with no air gaps.
511-6-1.06(2)(d) - Backflow Prevention, Air Gap (P) (d) Backflow Prevention, Air Gap. An air gap between the water supply inlet and the flood level rim of the plumbing fixture, equipment or nonfood equipment shall be at least twice the diameter of the water supply inlet and may not be less than 1 inch (25 mm). P

17C - physical facilities installed, maintained, and clean

Regulation: 511-6-1.07(5)(a),(b) - good repair, physical facilities maintained; cleaning, frequency & restrictions, cleaned often enough to keep them clean (c)

1 ptsCorrected: NoRepeat: No

Damaged gaskets were observed on the doors of the pizza prep top refrigeration unit.
511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation.

(a) Good Repair. All physical facilities shall be maintained in good repair.

17D - adequate ventilation and lighting; designated areas used

Regulation: 511-6-1.07(3)(f) - lighting intensity, adequate in food prep, storage & service areas (c)

1 ptsCorrected: NoRepeat: No

The light fixture inside the walk in refrigeration unit was not working, no light was observed inside the unit.
511-6-1.07(3)(f) - Lighting Intensity, adequate in food prep, storage & service areas (C) (f) Lighting Intensity. The light intensity shall be:

  1. At least 10 foot candles (108 lux) at a distance of 30 inches (75 cm) above the floor, in walk-in refrigeration units and dry food storage areas and in other areas and rooms during periods of cleaning.

Dec 20, 2023

Routine

Score: 943 violations

8-2B - toxic substances properly identified, stored, used

Regulation: 511-6-1.07(6)(b) - working containers, common name (pf)

4 ptsCorrected: YesRepeat: No

A spray bottle full of sanitizer solution was observed unlabelled on a shelf at the back of the facility. 511-6-1.07(6)(b) - Working Containers, Common Name (Pf) (b) Working Containers, Common Name. Working containers used for storing poisonous or toxic materials such as cleaners and sanitizers taken from bulk supplies shall be clearly and individually identified with the common name of the material. Pf Note: The Manager labelled the spray bottle immediately during the inspection.

15A - food and nonfood-contact surfaces cleanable, properly designed, constructed, and used

Regulation: 511-6-1.05(6)(q)1&3 - good repair & calibration (c)

1 ptsCorrected: NoRepeat: No

The reach in refrigeration unit was observed at 50 Degrees Fahrenheit.
511-6-1.05(6)(q)1&3 - Good Repair & Calibration (C) (q) Good Repair and Calibration.

  1. Utensils shall be maintained in a state of repair or condition that complies with the requirements specified under subsections (1) and (2) of this Rule or shall be discarded.
  2. Ambient air temperature, water pressure, and water temperature measuring devices shall be maintained in good repair and be accurate within the intended range of use. Note: The unit is not to be used to hold or cool potentially hazdous foods until it is repaired and the unit maintains an ambient temperature of 41 Degrees Fahrenheit or below.

17D - adequate ventilation and lighting; designated areas used

Regulation: 511-6-1.07(3)(f) - lighting intensity, adequate in food prep, storage & service areas (c)

1 ptsCorrected: NoRepeat: No

The light fixture inside the walk in refrigeration unit was not working, no light was observed inside the unit.
511-6-1.07(3)(f) - Lighting Intensity, adequate in food prep, storage & service areas (C) (f) Lighting Intensity. The light intensity shall be:

  1. At least 10 foot candles (108 lux) at a distance of 30 inches (75 cm) above the floor, in walk-in refrigeration units and dry food storage areas and in other areas and rooms during periods of cleaning.