Jan 23, 2026
Routine
4-2B - food-contact surfaces: cleaned & sanitized
Regulation: 511-6-1.05(6)(n) - manual and mechanical warewashing equipment, chemical sanitization-temperature, ph, concentration, hardness (p,pf)
Observed dishes being washed improperly in the three compartment sink. Chlorine sanitizer was observed in the wash sink. PIC corrected on site by properly setting up sinks. Once corrected, the chlorine sanitizer was observed at 50 ppm.
511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf) (n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows:
- A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P
Concentration Range Minimum Temperature
MG/L PH 10 or less oF (oC) PH 8 or less oF (oC)
25-49 120 (49) 120 (49)
50-99 100 (38) 75 (24)
100 55 (13) 55 (13)
12B - personal cleanliness
Regulation: 511-6-1.03(5)(j) - hair restraints (c)
Cook not wearing a hair restraint during food preparation.
511-6-1.03(5)(j) - Hair Restraints (C) (i) Hair Restraints.
-
Employees preparing or handling food shall use effective and clean, disposable or easily cleanable nets or other hair restraints approved by the Health Authority, worn properly to restrain loose hair including beards and mustaches longer than one half inch.
-
This does not apply to employees such as counter staff who only serve beverages and wrapped or packaged foods, hostesses, and wait staff if they present a minimal risk of contaminating exposed food, clean utensils and linens and unwrapped single-service and single-use articles.
18 - insects, rodents, and animals not present
Regulation: 511-6-1.07(2)(m) - outer openings protected (c)
Observed outer openings not protected. The backdoor is not properly sealed. The back door must be sealed to prevent the entry of pest. PIC will seal the back door 01/28/26. PIC will email a picture of the repair to Robert.Lewis1@dph.ga.gov by 1/28/26
511-6-1.07(2)(m) - Outer Openings Protected (C) (m) Outer Openings, Protected.
- Except as specified in paragraphs 2 through 5 of this subsection, outer openings of a food service establishment shall be protected against the entry of insects and rodents by:
(i) Filling or closing holes and other gaps along floors, walls, and ceilings;
(ii) Closed, tight-fitting windows; and
(iii) Solid, self-closing, tight-fitting doors.
-
The requirements in paragraph 1 of this subsection does not apply if a food service establishment opens into a larger structure, such as a mall, airport, or office building, or into an attached structure, such as a porch, and the outer openings from the larger or attached structure are protected against the entry of insects and rodents.
-
Exterior doors used as exits need not be self-closing if they are:
(i) Solid and tight-fitting;
(ii) Designated for use only when an emergency exists, by the fire protection authority that has jurisdiction over the food establishment; and
(iii) Limited-use so they are not used for entrance or exit from the building for purposes other than the designated emergency exit use.
- Except as specified in paragraphs 2 and 5 of this subsection, if the windows or doors of a food service establishment, or of a larger structure within which a food service establishment is located, are kept open for ventilation or other purposes or a temporary food service establishment is not provided with windows and doors as specified under paragraph 1 of this subsection, the openings shall be protected against the entry of insects and rodents by:
(i) 16 mesh to 1 inch (16 mesh to 25.4 mm) screens;
(ii) Properly designed and installed air curtains to control flying insects; or
(iii) Other effective means.
- The requirement in paragraph 4 of this subsection does not apply if flying insects and other pests are absent due to the location of the establishment, the weather, or other limiting condition.