Dec 19, 2025
Routine
4-2B - food-contact surfaces: cleaned & sanitized
Regulation: 511-6-1.05(6)(n) - manual and mechanical warewashing equipment, chemical sanitization-temperature, ph, concentration, hardness (p,pf)
Observed the hose not connected to the sanitizer solution for the dishwasher. The dishwasher is at 0 PPM chlorine. PIC attempted to connect the hose and prime the machine, but it still is not working. AutoChlor must be called to service the machine. A detailed service report must be emailed to sabrina.young@dph.ga.gov by 12/22 showing that the dishwasher has been serviced and is working properly. The 3-compartment sink must be set up to properly wash, rinse, and sanitize the dishes properly.
511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf) (n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows:
- A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P
Concentration Range Minimum Temperature
MG/L PH 10 or less oF (oC) PH 8 or less oF (oC)
25-49 120 (49) 120 (49)
50-99 100 (38) 75 (24)
100 55 (13) 55 (13)
-
An iodine solution shall have a minimum temperature of 68°F (20°C)P minimum concentration between 12.5 ppm and 25 ppm, P and pH of 5.0 or less or a pH no higher than the level for which the manufacturer specifies for the solution to be effective; P
-
A quaternary ammonium compound solution shall have a minimum temperature of 75ºF (24ºC), P have a concentration as specified in DPH Rule 511-6-1-.07(6)(g) and as indicated by the manufacturer’s use directions included in the labeling, P and be used only in water with 500 ppm hardness or less or in water having a hardness no greater than specified by the EPA-registered label use instructions; P
-
If another solution of a chemical specified under paragraphs 1 through 3 of this subsection is used, the permit holder shall demonstrate to the Health Authority that the solution achieves sanitization and the use of the solution shall be approved; P
-
If a chemical sanitizer other than chlorine, iodine, or a quaternary ammonium compound is used, it shall be applied in accordance with the EPA-registered label use instructions ;P and
-
If a chemical sanitizer is generated by a device located on-site at the food service establishment, it shall be used as specified in 1-5 of this subsection and shall be produced by a device that:
(i) complies with law as specified in sections 2(q)(1) and 12 of the Federal Insecticide, Fungicide, and Rodenticide Act (FIFRA), P
(ii) complies with 40 CFR 152.500 Requirement for Devices and 40 CFR 156.10 Labeling Requirements, P
(iii) displays the EPA device manufacturing facility registration number on the device, Pf and
(iv) is operated and maintained in accordance with manufacturer’s instructions. Pf.
- On-site chemical sanitizer generating equipment with active ingredients, such as copper, must be registered as pesticides. The active ingredient may be part of the equipment or separately added.
8-2B - toxic substances properly identified, stored, used
Regulation: 511-6-1.07(6)(f) - poisonous or toxic materials containers, prohibition (p)
Observed the sanitizer bucket at 200 PPM chlorine. PIC remade the solution to 100 PPM chlorine (COS).
511-6-1.07(6)(f) - Poisonous or Toxic Materials Containers, Prohibition (P) (f) Poisonous or Toxic Materials Containers, Prohibition. A container previously used to store poisonous or toxic materials shall not be used to store, transport, or dispense food, equipment, utensils, linens, single-service or single-use articles. P
8-2B - toxic substances properly identified, stored, used
Regulation: 511-6-1.07(6)(b) - working containers, common name (pf)
Observed two chemical bottles without a label to properly identify what was in the bottles. PIC identified the chemicals and labeled the bottles (COS).
511-6-1.07(6)(b) - Working Containers, Common Name (Pf) (b) Working Containers, Common Name. Working containers used for storing poisonous or toxic materials such as cleaners and sanitizers taken from bulk supplies shall be clearly and individually identified with the common name of the material. Pf
8-2B - toxic substances properly identified, stored, used
Regulation: 511-6-1.07(6)(c) - storage, separation (p)
Observed glass cleaner stored by lids and vanilla syrup at the server's station. PIC removed the items (COS).
511-6-1.07(6)(c) - Storage, Separation (P) (c) Storage, Separation. Poisonous or toxic materials shall be stored so they cannot contaminate food, equipment, utensils, linens, and single-service and single-use articles by:
-
Separating the poisonous or toxic materials by spacing or partitioning; P and
-
Locating the poisonous or toxic materials in an area that is not above food, equipment, utensils, linens, and single-service or single-use articles. This requirement does not apply to equipment and utensil cleaners and sanitizers that are stored in warewashing areas for availability and convenience if the materials are stored to prevent contamination of food, equipment, utensils, linens, and single-service and single-use articles. P