Main Street Grill

511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf) (n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows:

1. A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P Note: Observed dish machine to register at a chlorine concentration of 10ppm Chlorine. PIC instructed to set up alternate ware-washing procedure and contact maintenance for the dish machine. Sanitizer compartment registered at 100ppm Chlorine.

511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation.

(a) Good Repair. All physical facilities shall be maintained in good repair. Note: Missing light shield on light above ware washing area. PIC instructed to replace light shield.

511-6-1.06(1)(g),(h) - Water Supply, Capacity; Pressure (Pf) 2. Hot water generation and distribution systems shall be sufficient to meet the peak hot water demands throughout the food service establishment. Pf Note: No hot water available in women's restroom hand sink.

511-6-1.05(1)(a) - Materials, General Requirements (P, C) (1) Materials.

(a) General Requirements. Utensils and food-contact surfaces of equipment shall be made of materials that do not allow the migration of deleterious substances or impart colors, odors, or tastes to food and under normal use conditions, and shall be: P safe P, durable, corrosion-resistant, and nonabsorbent. In addition, materials shall be sufficient in weight and thickness to withstand repeated warewashing and shall be finished to have a smooth, easily cleanable surface. Materials shall be resistant to pitting, chipping, crazing, scratching, scoring, distortion and decomposition. Note: Inspector observed multiple pitted and chipped knives in kitchen. PIC stated they would purchase new knives.

511-6-1.05(3)(h),(i) - Temperature Measuring Device, Manual Warewashing; Sanitizing Solutions, Testing Device (Pf) (i) Sanitizing Solutions, Testing Devices. A test kit or other device that accurately measures the concentration in mg/L of sanitizing solutions shall be provided. Pf Note: No test strips to test the chlorine concentration of the dish machine and sanitizer buckets were available in the facility.

511-6-1.06(5)(o),(p) - Using Drain Plugs; Maintaining Refuse Areas (C) (o) Using Drain Plugs. Drains in receptacles and waste handling units for refuse, recyclables, and returnables shall have drain plugs in place. Note: No drain plug was observed in waste receptacle.