Savannah, Chatham County

The Georgia Tasting Room

306 W ST JULIAN ST SAVANNAH, GA 31401

Food
Latest score
94
Feb 4, 2026
City
Savannah
County
Chatham
Inspections
3

Score history

Inspection scores over time for this facility.

Inspection history

Georgia inspection history is score-based, with violations grouped under each recorded inspection.

Feb 4, 2026

Routine

Score: 942 violations

2-2D - adequate handwashing facilities supplied & accessible

Regulation: 511-6-1.07(3)(b) - hand drying provision (pf)

4 ptsCorrected: YesRepeat: No

Observed both hand washing sinks in the bar area to not have any paper towels readily stocked.

CA: PIC added paper towels to station. Each handwashing sink or group of adjacent handwashing sinks shall be provided with individual, disposable towels.

15B - warewashing facilities: installed, maintained, used; test strips

Regulation: 511-6-1.05(3)(h),(i),(j) - temperature measuring device, manual warewashing; sanitizing solutions, testing device (pf)

1 ptsCorrected: NoRepeat: Yes

Observed facility to not have any test strips for dishwasher.

RCA: Temperature Measuring Devices, Manual and Mechanical Warewashing.

  1. In manual warewashing operations, a temperature measuring device shall be provided and readily accessible for frequently measuring the washing and sanitizing temperatures. Pf

  2. In hot water mechanical warewashing operations, an irreversible registering temperature indicator shall be provided and readily accessible for measuring the utensil surface temperature. Pf

Feb 14, 2025

Routine

Score: 911 violation

6-1A - proper cold holding temperatures

Regulation: 511-6-1.04(6)(f) - time/temperature control for safety; cold holding (p)

9 ptsCorrected: YesRepeat: No

Observed temperature of pimento cheese to be at 54F in cold-holding unit near entrance. Observed an ambient temperature reading of 50F in unit. COS: PIC discarded all pimento cheese and will have unit serviced.

Jul 6, 2023

Routine

Score: 953 violations

18 - insects, rodents, and animals not present

Regulation: 511-6-1.07(2)(m) - outer openings protected (c)

3 ptsCorrected: NoRepeat: No

Observed door open at arrival into facility which is affecting temp of open reach in cooler next to it.

RCA: 511-6-1.07(2)(m) - Outer Openings Protected (C) (m) Outer Openings, Protected.

  1. Except as specified in paragraphs 2 through 5 of this subsection, outer openings of a food service establishment shall be protected against the entry of insects and rodents by:

(i) Filling or closing holes and other gaps along floors, walls, and ceilings;

(ii) Closed, tight-fitting windows; and

(iii) Solid, self-closing, tight-fitting doors.

  1. The requirements in paragraph 1 of this subsection does not apply if a food service establishment opens into a larger structure, such as a mall, airport, or office building, or into an attached structure, such as a porch, and the outer openings from the larger or attached structure are protected against the entry of insects and rodents.

  2. Exterior doors used as exits need not be self-closing if they are:

(i) Solid and tight-fitting;

(ii) Designated for use only when an emergency exists, by the fire protection authority that has jurisdiction over the food establishment; and

(iii) Limited-use so they are not used for entrance or exit from the building for purposes other than the designated emergency exit use.

  1. Except as specified in paragraphs 2 and 5 of this subsection, if the windows or doors of a food service establishment, or of a larger structure within which a food service establishment is located, are kept open for ventilation or other purposes or a temporary food service establishment is not provided with windows and doors as specified under paragraph 1 of this subsection, the openings shall be protected against the entry of insects and rodents by:

(i) 16 mesh to 1 inch (16 mesh to 25.4 mm) screens;

(ii) Properly designed and installed air curtains to control flying insects; or

(iii) Other effective means.

  1. The requirement in paragraph 4 of this subsection does not apply if flying insects and other pests are absent due to the location of the establishment, the weather, or other limiting condition.

14C - single-use/single-service articles: properly stored, used

Regulation: 511-6-1.05(10)(e)1&3 - single-service/single-use items stored 6" off floor in clean, dry location (c)

1 ptsCorrected: NoRepeat: No

Observed closet of single use cups and other paper/plastic products stacked up on floor.

RCA: 511-6-1.05(10)(e)1&3 - Single-Service/Single-Use items stored 6" off floor in clean, dry location (C) (e) Equipment, Utensils, Linens, and Single-Service and Single-Use Articles.

  1. Except as specified in paragraph 4 of this subsection, cleaned equipment and utensils, laundered linens, and single-service and single-use articles shall be stored:

(i) In a clean, dry location;

(ii) Where they are not exposed to splash, dust, or other contamination; and

(iii) At least 6 inches (15 centimeters) above the floor. 3. Single-service and single-use articles shall be stored as specified under paragraph 1 of this subsection and shall be kept in the original protective package or stored by using other means that afford protection from contamination until used.

15B - warewashing facilities: installed, maintained, used; test strips

Regulation: 511-6-1.05(6)(d),(e) - warewashing equipment, cleaning frequency; warewashing machines, manufacturers' operating instructions (c)

1 ptsCorrected: NoRepeat: No

Observed no high heat test strips for dish machine.

RCA: 511-6-1.05(6)(d),(e) - Warewashing Equipment, Cleaning Frequency; Warewashing Machines, Manufacturers' Operating Instructions (C) (d) Warewashing Equipment, Cleaning Frequency. A warewashing machine; the compartments of sinks, basins, or other receptacles used for washing and rinsing equipment, utensils, or raw foods, or laundering wiping cloths; and drainboards or other equipment used to substitute for drainboards shall be cleaned before use; throughout the day at a frequency necessary to prevent recontamination of equipment and utensils and to ensure that the equipment performs its intended function; and if used, at least every 24 hours.

(e) Warewashing Machines, Manufacturers' Operating Instructions.

  1. A warewashing machine and its auxiliary components shall be operated in accordance with the machine's data plate and other manufacturer's instructions.

  2. A warewashing machine's conveyor speed or automatic cycle times shall be maintained accurately and timed in accordance with the manufacturer's specifications.