St. Regis Main Kitchen

Observed tuna thawing under running water while still in vacuum sealed packaging. CA: Advised PIC to remove fish from packaging while still frozen then start thawing process.

511-6-1.04(6)(c) - Thawing (C) (c) Thawing. Except as specified in paragraph 4 of this subsection, time/temperature control for safety food shall be thawed:

1. Under refrigeration that maintains the food temperature at 41°F (5°C) or less; PF or

2. Completely submerged under running water:

(i) At a water temperature of 70°F (21°C) or below, PF

(ii) With sufficient water velocity to agitate and float off loose particles in an overflow PF, and

(iii) For a period of time that does not allow thawed portions of ready-to-eat food to rise above 41°F (5°C), or

(iv) For a period of time that does not allow thawed portions of a raw animal food requiring cooking to be above 41°F (5°C), for more than 4 hours including:

(I) The time the food is exposed to the running water and the time needed for preparation for cooking PF, or

(II) The time it takes under refrigeration to lower the food temperature to 41°F (5°C) PF;

3. As part of a cooking process if the food that is frozen is:

(i) Cooked as specified under subsections (5)(a)1 or 2 or (5)(b) or 5(e) of this Rule PF, or

(ii) Thawed in a microwave oven and immediately transferred to conventional cooking equipment, with no interruption in the process PF; or

4. Using any procedure if a portion of frozen ready-to-eat food is thawed and prepared for immediate service in response to an individual consumer's order.

5. Reduced oxygen packaged fish that bears a label indicating that it is to be kept frozen until time of use shall be removed from the reduced oxygen environment:

(i) Prior to its thawing under refrigeration that maintains the food temperature at 41°F (5°C) or less; or

(ii) Prior to, or immediately upon completion of its thawing, using procedures to completely submerge in running water as specified in paragraph 2 of this subsection.

Observed multiple dishes stacked together while wet near dish washing area. CA: Advised PIC to allow dishes to air dry before stacking together.

511-6-1.05(10)(a) - Equipment & Utensils, Air-Drying Required (C) (10) Protection of Clean Items.

(a) Equipment and Utensils, Air-Drying Required. After cleaning and sanitizing, equipment and utensils:

1. Shall be air-dried or used after adequate draining before contact with food; and

2. May not be cloth dried except that utensils that have been air-dried may be polished with cloths that are maintained clean and dry.

Observed tuna thawing in multiple coolers while still vacuum sealed. CA: Advised PIC to remove all tuna from vacuum seal packaging before starting thawing process.

511-6-1.04(6)(c) - Thawing (C) (c) Thawing. Except as specified in paragraph 4 of this subsection, time/temperature control for safety food shall be thawed:

1. Under refrigeration that maintains the food temperature at 41°F (5°C) or less; or

2. Completely submerged under running water:

(i) At a water temperature of 70°F (21°C) or below,

(ii) With sufficient water velocity to agitate and float off loose particles in an overflow, and

(iii) For a period of time that does not allow thawed portions of ready-to-eat food to rise above 41°F (5°C), or

(iv) For a period of time that does not allow thawed portions of a raw animal food requiring cooking to be above 41°F (5°C), for more than 4 hours including:

(I) The time the food is exposed to the running water and the time needed for preparation for cooking, or

(II) The time it takes under refrigeration to lower the food temperature to 41°F (5°C);

3. As part of a cooking process if the food that is frozen is:

(i) Cooked as specified under subsections (5)(a)1 or 2 or (5)(b) of this Rule, or

(ii) Thawed in a microwave oven and immediately transferred to conventional cooking equipment, with no interruption in the process; or

4. Using any procedure if a portion of frozen ready-to-eat food is thawed and prepared for immediate service in response to an individual consumer's order.

5. Reduced oxygen packaged fish that bears a label indicating that it is to be kept frozen until time of use shall be removed from the reduced oxygen environment:

(i) Prior to its thawing under refrigeration that maintains the food temperature at 41°F (5°C) or less; or

(ii) Prior to, or immediately upon completion of its thawing, using procedures to completely submerge in running water as specified in paragraph 2 of this subsection.

Observed cutting boards on prep top cooler near grill heavily scored with black substance inside gashes. CA: Advised PIC to replace cutting boards.

511-6-1.05(2)(c) - Multiuse Food-Contact Surfaces (Pf) (c) Multiuse Food-Contact Surfaces.

1. Multiuse food-contact surfaces shall be:

(i) Smooth; Pf

(ii) Free of breaks, open seams, cracks, chips, inclusions, pits, and similar imperfections; Pf

(iii) Free of sharp internal angles, corners, and crevices; Pf

(iv) Finished to have smooth welds and joints; Pf and

(v) Except as specified in paragraph 2 of this subsection, accessible for cleaning and inspection by one of the following methods:

(I) Without being disassembled, Pf

(II) By disassembling without the use of tools, Pf or

(III) By easy disassembling with the use of handheld tools commonly available to maintenance and cleaning personnel such as screwdrivers, pliers, open-end wrenches, and Allen wrenches. Pf

2. The requirement in paragraph 1(v) of this subsection does not apply to cooking oil storage tanks, Distribution lines for cooking oils, or beverage syrup lines or tubes.

Observed two employees with watches in the kitchen. One employee was walking around the prep when EHS spoke to him about the watch. The other person was preparing food on the grill prep line when EHS step around the corner.

Except for a plain ring such as a wedding band food employees may not wear jewelry including medical information jewelry on their arms and hands while preparing food.

EHS had both employees remove their watches before starting their next task.

Observed a cutting boards on the first PTC that were heavily scored.

1. Multiuse food-contact surfaces shall be:

(i) Smooth; Pf

(ii) Free of breaks, open seams, cracks, chips, inclusions, pits, and similar imperfections; Pf

(iii) Free of sharp internal angles, corners, and crevices; Pf

(iv) Finished to have smooth welds and joints; Pf and

(v) Except as specified in paragraph 2 of this subsection, accessible for cleaning and inspection by one of the following methods:

(I) Without being disassembled, Pf

(II) By disassembling without the use of tools, Pf or

(III) By easy disassembling with the use of handheld tools commonly available to maintenance and cleaning personnel such as screwdrivers, pliers, open-end wrenches, and Allen wrenches. Pf

PIC will either have them replaced or professionally sanded.

Observed a quats solution in the 3C sink above the recommended range. The recommended range is 150 - 400 ppm. See comments for readings.

3. A quaternary ammonium compound solution shall have a minimum temperature of 75ºF (24ºC), P have a concentration as specified in DPH Rule 511-6-1-.07(6)(g) and as indicated by the manufacturer’s use directions included in the labeling, P and be used only in water with 500 ppm hardness or less or in water having a hardness no greater than specified by the EPA-registered label use instructions; P

Employees used water to dilute the concentration of the solution.

Observed two can openers with heavily soiled blades and heavily scored cutting boards on fridge for the grill prep line.

1. Equipment food-contact surfaces and utensils shall be clean to sight and touch. Pf.

PIC discarded the cutting boards and had the can openers cleaned.

Observed date marked in-house sauces and pasta present past the disposal date in the first walk in fridge.

1. A food that requires datemarking shall be discarded if it:

(i) Exceeds 7 days, not including the time that the product is frozen; P

(ii) Is in a container or package that does not bear a date or day; P or

(iii) Is appropriately marked with a date or day that exceeds 7 days . P

2. Refrigerated, ready-to-eat, time / temperature control for safety food prepared in a food service establishment and dispensed through a vending machine with an automatic shutoff control shall be discarded if it exceeds 7 days. P

PIC had an employee discarded these out of date items.

Observed several date marked items that were present in the RIC on the wall opposite the grill prep area. 8/31, 8/28 and 9/05.

1. A food that requires datemarking shall be discarded if it:

(i) Exceeds 7 days, not including the time that the product is frozen; P

(ii) Is in a container or package that does not bear a date or day; P or

(iii) Is appropriately marked with a date or day that exceeds 7 days . P

2. Refrigerated, ready-to-eat, time / temperature control for safety food prepared in a food service establishment and dispensed through a vending machine with an automatic shutoff control shall be discarded if it exceeds 7 days. P PIC discard these items.

Observed several heavily scored cutting through out the kitchen that were not in use during the time of the inspection.

1. Multiuse food-contact surfaces shall be:

(i) Smooth; Pf

(ii) Free of breaks, open seams, cracks, chips, inclusions, pits, and similar imperfections; Pf

(iii) Free of sharp internal angles, corners, and crevices; Pf

(iv) Finished to have smooth welds and joints; Pf and

(v) Except as specified in paragraph 2 of this subsection, accessible for cleaning and inspection by one of the following methods:

(I) Without being disassembled, Pf

(II) By disassembling without the use of tools, Pf or

(III) By easy disassembling with the use of handheld tools commonly available to maintenance and cleaning personnel such as screwdrivers, pliers, open-end wrenches, and Allen wrenches. Pf PIC will have all of these cutting boards discarded and replaced.

Observed several broken lights under the grill prep hood that services the main dining area. 3. At least 50 foot candles (540 lux) at a surface where a food service employee is working with food or working with utensils or equipment such as knives, slicers, grinders, or saws where employee safety is a factor. PIC contacted maintenance to rectify the issue.