Jul 22, 2025
Routine
19 - adequate turnover rate
Unable to determine adequate turnover rate due to flow meter not being operational
111 WASHINGTON PKWY JEFFERSON, GA 30549
Inspection scores over time for this facility.
Georgia inspection history is score-based, with violations grouped under each recorded inspection.
Routine
Unable to determine adequate turnover rate due to flow meter not being operational
Permit/Opening
Routine
Regulation: 511-3-5-.07(1)(b) - (b) turnover rates for pools by type listed below: type
Flowmeter observed at 60gpm; flow rate must read 96pgm or higher for adequate turnover.
Re-inspection
Permit/Opening
Free Chlorine too high.
pH too low.
Re-inspection
Turnover rate inadequate
Routine
Unable to determine flow rate for adequate turnover
Regulation: 511-3-5-.07(4)(b) - (b) a flow meter measuring the rate of flow through the filter system with an appropriate range readable in gallons per minute (gpm) and accurate within ten percent actual flow shall be provided. the flow indicator shall be capable of measuring from
No flow meter on piping, install flow meter.
Regulation: 511-3-5-.17(4) - (4) stabilizer (if used) cyanuric acid,ppm ideal: 30-50 maximum: 90 comments: if stabilizer is: too high: - may reduce chlorine efficacy too low: - chlorine residual rapidly destroyed by sunlight note: stabilizer is not needed in indoor or br
Cyanuric acid level exceeds maximum
Permit/Opening
Regulation: 511-3-5-.07(1)(b) - (b) turnover rates for pools by type listed below: type
Unable to determine flow rate for adequate turnover
Regulation: 511-3-5-.07(4)(b) - (b) a flow meter measuring the rate of flow through the filter system with an appropriate range readable in gallons per minute (gpm) and accurate within ten percent actual flow shall be provided. the flow indicator shall be capable of measuring from
No flow meter on piping, install flow meter to determine flow rate