Inspection Atlas
Georgia Inspection Scores
Locality
GAFL
Hinesville, Liberty County

Hinesville Swimming Pool

607 E OGLETHORPE HWY HINESVILLE, GA 31313

Pool
Latest score
93
May 21, 2026
City
Hinesville
County
Liberty
Inspections
6

Score history

Inspection scores over time for this facility.

Inspection history

Georgia inspection history is score-based, with violations grouped under each recorded inspection.

May 21, 2026

Permit/Opening

Score: 933 violations
View source record

19 - adequate turnover rate

Regulation: 511-3-5-.07(1)(b) - (b) turnover rates for pools by type listed below: type

5 ptsCorrected: NoRepeat: No

Observed no flow registering on flow meter. Automated control shows 700gpm

31 - dressing showers: clean, maintained, hot and cold water available

Regulation: 511-3-5-.19(1)(e ) - (e) hot and cold water under pressure shall be provided in dressing facility showers.

1 ptsCorrected: NoRepeat: No

Observed no hot water in showers or sinks in either locker room.

37 - other violations of the chapter

1 ptsCorrected: NoRepeat: No

511-3-5-.11(3)(g)Observed equalizer line under skimmer to left side of stairs (facing stairs from water).

The skimmer equalizer lines shall be protected by an approved cover/grate.

Jul 22, 2025

Routine

Score: 912 violations
View source record

28 - flow meter: appropriate range and location

Regulation: 511-3-5-.07(4)(b) - (b) a flow meter measuring the rate of flow through the filter system with an appropriate range readable in gallons per minute (gpm) and accurate within ten percent actual flow shall be provided. the flow indicator shall be capable of measuring from

5 ptsCorrected: NoRepeat: No

Observed flow meter was not registering the flow rate of the pool. CA: A flow meter measuring the rate of flow through the filter system with an appropriate range readable in gallons per minute (GPM) and accurate within ten percent actual flow shall be provided.

17 - skimmers/gutters maintained and operable

Regulation: 511-3-5-.11(3)(d) - (d) each skimmer shall have a weir that adjusts automatically to variations in water level over a minimum range of four inches.

4 ptsCorrected: NoRepeat: No

Observed that multiple weirs were missing from the skimmers.

May 22, 2025

Permit/Opening

Score: 1000 violations
View source record
No violations recorded for this inspection.

Jul 23, 2024

Routine

Score: 793 violations
View source record

6 - proper disinfectant level

Regulation: .17((1)(c) - proper disinfectant level

15 ptsCorrected: YesRepeat: No

Observed chlorine level was reading at 1.08. COS: CPO instructed all swimmers to get out of the pool while he added chlorine. Inspector continued inspection and checked chlorine again at the end of the inspection. Free Chlorine read at 2.63. Pool allowed to remain open.

28 - flow meter: appropriate range and location

Regulation: 511-3-5-.07(4)(b) - (b) a flow meter measuring the rate of flow through the filter system with an appropriate range readable in gallons per minute (gpm) and accurate within ten percent actual flow shall be provided. the flow indicator shall be capable of measuring from

5 ptsCorrected: NoRepeat: Yes

Observed flow meter was not registering the flow rate of the pool. CA: A flow meter measuring the rate of flow through the filter system with an appropriate range readable in gallons per minute (GPM) and accurate within ten percent actual flow shall be provided.

24 - piping identified and marked

Regulation: 511-3-5-.08(6) - (6) all piping shall be marked with directional arrows as necessary to determine flow direction. all piping in the equipment room shall be permanently identified by its use and the pool and or aquatic feature it serves.

1 ptsCorrected: NoRepeat: Yes

Observed there were no labels and directional arrows on piping in pump room. CA: All piping shall be marked with directional arrows as necessary to determine flow direction.

May 15, 2024

Permit/Opening

Score: 933 violations
View source record

28 - flow meter: appropriate range and location

Regulation: 511-3-5-.07(4)(b) - (b) a flow meter measuring the rate of flow through the filter system with an appropriate range readable in gallons per minute (gpm) and accurate within ten percent actual flow shall be provided. the flow indicator shall be capable of measuring from

5 ptsCorrected: NoRepeat: No

Observed flow meter not registering a flow rate

24 - piping identified and marked

Regulation: 511-3-5-.08(6) - (6) all piping shall be marked with directional arrows as necessary to determine flow direction. all piping in the equipment room shall be permanently identified by its use and the pool and or aquatic feature it serves.

1 ptsCorrected: NoRepeat: No

Observed no labels and directional arrows on piping in pump room.

31 - dressing showers: clean, maintained, hot and cold water available

1 ptsCorrected: NoRepeat: No

Observed no hot water in showers or sinks in either locker room.

May 25, 2023

Permit/Opening

Score: 951 violation
View source record

28 - flow meter: appropriate range and location

Regulation: 511-3-5-.07(4)(b) - (b) a flow meter measuring the rate of flow through the filter system with an appropriate range readable in gallons per minute (gpm) and accurate within ten percent actual flow shall be provided. the flow indicator shall be capable of measuring from

5 ptsCorrected: NoRepeat: Yes

Observed flow meter was registering at 639GPM, much higher than the designed flow rate.

511-3-5-.07(4)(b) - (b) A flow meter measuring the rate of flow through the filter system with an appropriate range readable in gallons per minute (GPM) and accurate within ten percent actual flow shall be provided. The flow indicator shall be capable of measuring from (b) A flow meter measuring the rate of flow through the filter system with an appropriate range readable in gallons per minute (GPM) and accurate within ten percent actual flow shall be provided. The flow indicator shall be capable of measuring from one-half to at least one and one-half times the design flow rate. The gauge shall be located after the filtering equipment and in such location on the return line, so as to measure the total amount of water returning to the pool according to the manufacturer’s installation specifications.